Amplify-and-forward

关于改进设计的状态反馈控制器的网络控制系统，详细的对参数的改变进行了设计。(Improvement of State Feedback Controller Design for Networked Control Systems)

this is the 4th file of coding

CTS协议的主程序，和aloha的主程序(CTS protocol of the main program, and the main routine of aloha)

说明：  文件包含了层次分析法、熵权法和TOPSIS方法计算参数时用到的函数(The file contains the functions used in the calculation of parameters by analytic hierarchy process (AHP), entropy weight method and TOPSIS method)

无线传感器网络leach协议，在matlab上的改进算法，考虑了能量(Leach protocol of wireless sensor networks, the improved algorithm in matlab, taking into account energy)

Implementation of AVL Tree

毕业设计的基于8QAM+zcz序列的准同步CDMA通信系统仿真(　　　This article will be given below 8QAM+ ZCZ sequence sets up method and analysis, will further introduce the relevant definitions zero correlation sequence and some properties and characteristics, including non-cycle related, cycle-related, Qi cycle and other characteristics. The reason why is because the study of these theories using this sequence, in the Gaussian channel conditions and system performance in terms of interference is very similar to the synchronization system and the system performance is far superior to an asynchronous system, and the extended sequence comparison the original sequence has better performance.)

列车站间一次惰行的计算程序（自编），加速惰行最后减速，定时定距离完成任务(train moving between two station)

关于最小换乘次数的最佳公交路线模型的matlab程序, 关键词:广度优化搜索 最佳路线 换车次数(The smallest change on the frequency of the best bus route model matlab procedures, Keywords: breadth optimize the best route to change the number of search)

利用滑动相关来捕获伪码，并且计算在各个信噪比下的检测概率。(The use of sliding-related pseudo-code to capture and calculate the probability of detection under various signal to noise ratio.)