GA

Time analysis method for knock detection in injection engine

This algorithm routing by reinforcement learning

关于bpsk的ber仿真与理论性能比较，可运行(Ber simulation and theoretical performance on bpsk comparison, you can run)

matlab cod efor 2013 ieee paper a two level fh cdma

信号为两个正弦信号加高斯白噪声，各正弦信号的信噪比均为10dB，长度为N，信号频率分别为 和 ，初始相位 ，取 ， 取不同数值：0.3，0.25。 为采样频率。分别用Levinson递推法和Burg法进行功率谱估计，并分析改变数据长度、模型阶数对谱估计结果的影响。(Signal into two sinusoidal signals applied Gaussian white noise, the SNR of each sinusoidal signals are 10dB, a length of N, respectively, and the signal frequency, initial phase, take, take different values: 0.3,0.25. It is the sampling frequency. Respectively Levinson recursion method and Burg method for power spectrum estimation, and change the length of the data analysis, the impact of model order estimation result spectrum.)

说明：  基于yalmip调用gurobi求解器，求解ieee 6 bus system 机组组合状态优化，并画出最优组合策略图。(Based on yalmip, the gurobi solver is called to solve the IEEE 6 bus system unit commitment state optimization, and the optimal commitment strategy chart is drawn.)

Jacknife method, very good

this code gives various types of filter designs like chebbyshev and butterworth filters

This a package containing all sources code for matlab for "blotch and scratch detection based on Rank orederd differences" or ROD.

本程序利用粒子群算法（PSO算法），求BANANA函数在（1，1）附近的极小值(This program makes use of particle swarm optimization (PSO algorithm), find BANANA function (1,1) near the minimum)