kal

说明：  在simulink中搭建永磁同步电机模型，并采用三环控制对其进行位置控制。(The permanent magnet synchronous motor model is built in Simulink, and its position is controlled by three loop control.)

AC motor, dq transformation,

这是一个三相交流的下垂控制仿真，使用传统的下垂控制策略(This is droop control model of three phase grid using the traditional droop control method)

IEEE上关于人耳图像识别的论文：使用改进的非负矩阵分解的人耳识别(Ear Recognition using Improved Non-Negative Matrix Factorization )

matlab仿真MM1。非常好的源代码。(matlab simulation MM1. Very good source code.)

基于特征目标跟踪程序 matlab 程序(基于特征目标跟踪程序)

熵与条件熵，疑义度，噪声熵，互信息等计算程序熵与条件熵，疑义度，噪声熵，互信息等计算程序(Entropy and conditional entropy, equivocation, noise Entropy, mutual information, and procedures for Entropy and conditional entropy calculation, doubt, noise Entropy, mutual information calculation program)

RLS程序代码，经测试绝对能用，大家一起分享(RLS)

surface chart GA-wiley-matlab surface chart GA-wiley-matlab

均匀圆阵仿真:m=8 阵元数 azimuth=[-55 0 40] 方位角 p=length(azimuth) 信号源个数 snap=1000 最大快拍数 drl=0.5 圆阵半径与波长之比 snr=15 信噪比dB 流程：1、构造信号2、构造噪声阵列流型矩阵3、观测信号4、观测信号协方差矩阵5、求解特征值与特征向量6、显示图谱。(The uniform circular array simulation: m = 8 element azimuth = [-55 0 40] azimuth p = length (azimuth) number of source snap = 1000 maximum number of snapshots drl = 0.5 ratio of the radius of the circular array wavelength snr = 15 SNR dB process: 1, constructed signal structure noise array manifold matrix 3, the observed signals observed signals covariance matrix 5 eigenvalue and eigenvector 6, display the map.)