dePnn(optimize-the-learning-rate)

Program: Lognormal Distribution Simulation Histograms C3

max loyd quantization for image processing

第一步是计算输人信号单边功率谱密度（ESD）。使用快 ％速傅里叶（FFr）算法将信号从时域转换到频域。因为FFr算法的输出是离散谱，而这 ％里我们需要的是连续谱，因此需要引人不同的比例因子来实现从离散谱到连续谱的转换。 ％在第二步中，我们利用迭代算法计算出相对于特定阂值的ESD的最高和最低频率，从而 ％估算出被检测信号所占用的带宽。这种算法同时适用于基带信号和已调制信号。最后， ％在第三步中，我们给出了输出图形的原代码。(The first step is calculating the input signal unilateral power spectral density (ESD). The use of fast Fourier speed (FFr) algorithm for the signal conversion from time domain to frequency domain. FFR algorithm because the output is a discrete spectrum, which we need is a continuous spectrum, so the need for food of different scale factor to achieve from the discrete spectrum to continuous spectrum conversion. In the second step, we use iterative algorithm to calculate a specific threshold in relation to the ESD of the highest and lowest frequency, thus estimated to be occupied by the signal detection bandwidth. This algorithm applies to both baseband signal and modulation signals. Finally, in the third step, we give the graphical output of the original code.)

其中datarec.csv文件为原始三相电压电流数据文件，该matlab程序能够实现三相电压电流的谐波分析以及有功无功功率计算，并得到谐波补偿波形。(The datarec.csv file is the original three-phase voltage and current data file. The matlab program can realize the harmonic analysis of the three-phase voltage and current and the active and reactive power calculation, and obtain the harmonic compensation waveform.)

基于matlab软件，实现3D有边界的voronoi图。(A Voronoi diagram with a boundary for 3D)

基于3Gpp 标准化的 卷积码译码算法matlab程序(Convolutional decoder for 802.16)

采用口面积分的方法来计算天线方向图，天线设计常用(Orifice area divided by the method to calculate the antenna pattern, antenna design used)

说明：  用matlab 7.0 adaptse函数完成的 基于lms的自适应滤波器(Done with matlab 7.0 adaptse function of the adaptive filter based lms)

《matlab有限元分析与应用》书后源代码，在matble中运行，对于有限元的初学者很有用。("Matlab Finite Element Analysis and Application" after the source code, in matble run, FEM for beginners useful.)

该源代码应用于对传感器接收到的原始时域信号进行c扫描成像，应用于无损检测领域。(The source code is applied to the sensor receives the original time-domain signal c-scan imaging, used in non-destructive testing in the field.)