KL2

说明：  有两个程序，用于研究Mallet算法及滤波器设计和消噪(are two procedures for research and Mallet filter algorithm design and denoising)

bracket optimization method

kpca原始程序和小波去噪部分，用于数据降维和特征提取比较实用(kpca part of the original program and wavelet denoising for data dimensionality reduction and feature extraction more practical)

基于虚拟力的无线传感器网络覆盖算法，完整可靠，可直接输出结果(Wireless sensor network coverage algorithm based on virtual force, complete and reliable, and can output directly)

estymacja w matlabie

设计音频降噪算法，并用MATLAB仿真实现。 1）读入一段音频后添加噪声，必须包括两种不同的噪声，信噪比：0dB~10dB； 2）分别采用滑动平均滤波器，直接频域滤波，以及谱分析后设计滤波器滤波三种方法实现，并对比效果。 3）给出各种方案的设计依据、代码、频响曲线，以及输入输出对比图。(Audio noise reduction algorithm design, and use MATLAB Simulation. 1) Read after adding noise into an audio, it must include two different kinds of noise, SNR: 0dB ~ 10dB 2) respectively moving average filter directly in the frequency domain filtering, and the filter is designed to achieve three methods filter after spectral analysis and contrast. 3) Give the design basis, code, frequency response curve, and input and output comparison chart of the various programs.)

根据实际风速时间序列，建立风速的马尔可夫链模型(According to the actual wind speed time series, the Chian Markov of the wind speed is established.)

it is a ieee paper on fact devices used for ower flow controller

盲信号自然梯度法盲分离程序，用于进行瞬时盲分离(Natural Gradient Blind Signal Separation legal procedures, for instantaneous blind source separation)

本例程是针对不同通道之间采集的声音信号之间波形的相位时延差进行估计，(The routine is different between the acquisition of voice-channel signal delay between the waveform of the phase difference estimate,)