kalman-fiter

一般周期调制信号下的模拟ppm信号matlab仿真(general cycle modulation signal simulation ppm Matlab Signal Simulation)

solar pv array model of msx60

自己编写的遗产算法程序。在matlab环境下编写的m文件。经测试好用，基本，原理简单。(I have written legacy algorithm. In the matlab environment prepared m files. Tested easy to use, the basic principle is simple.)

产生BCH码多项式，其中码字长度为N，消息长度为K(BCH code generated polynomial, which codeword length N, message length K)

data mining agglomerative clustering

经典功率谱估计的MATLAB程序，需要的可以看看，验证过了(Classical power spectrum estimation of the MATLAB program, the need to look at, been verified)

几乎所有IEEE节点系统的MATLAB潮流程序(IEEE bus system almost all the current procedures for MATLAB)

Three-phase electric power is a common method of alternating-current electric power generation, transmission, and distribution.[1] It is a type of polyphase system and is the most common method used by electrical grids worldwide to transfer power. It is also used to power large motors and other heavy loads. A three-phase system is usually more economical than an equivalent single-phase or two-phase system at the same voltage because it uses less conductor material to transmit electrical power.[2] The three-phase system was independently invented by Galileo Ferraris, Mikhail Dolivo-Dobrovolsky and Nikola Tesla in the late 1880s.

This is the full commands for the matlab

Transfer functions between interfaces can be easily calculated by division of the total (=upward+downward) displacement response on the corresponding interfaces.