73032871OFDM_cyclic_spectrum

数字调制-OFDM-QPSK-峰均比-资料,很好很详细，学习ofdm很好的资料(Digital Modulation-OFDM-QPSK-PAR- information, very very detailed, very good information to learn ofdm)

16QAM调制信号的GAD定时恢复，对定时恢复环路的验证和实现(Gardner Timing Recovery for 16QAM)

说明：  7. 单径瑞利信道中的两发一收STBC： (1) 分析误码率的理论性能，画出比特信噪比与误码率的关系曲线。 (2) 请设计一种具体的导引辅助的信道估计方法，用Simulink进行仿真，测量BPSK调制时的误码率性能。画出比特信噪比与信道估计均方误差的关系曲线，画出比特信噪比与误码率的关系曲线。(7. Two outgoing and one outgoing STBC in single-path Rayleigh channel: (1) analyze the theoretical performance of bit error rate and draw the curve of the relationship between bit SNR and bit error rate. (2) please design a specific navigation-assisted channel estimation method, Simulink simulation, measurement of BPSK modulation error rate performance.The relation curve between the bit signal-noise ratio and the mean square error of channel estimation is drawn, and the relation curve between the bit signal-noise ratio and the bit error rate is drawn.)

水声声线仿真，基于射线模型。文章包含仿真条件和说明。文章附件为程序。(Underwater acoustic line simulation, based on the ray model. The article contains simulation conditions and instructions. The article appendix is the procedure.)

线性调频信号和相位编码信号（七位巴克码）及他们的混合调制信号在matlab中的实现(The realization of the chirp signal and the phase-encoded signal (seven Barker code) and their hybrid modulation signal in matlab)

说明：  这是关于多输入多输出正交频分复用索引的代码(Multiple input multiple output orthogonal frequency division multiplexing index modulation simulation code)

本人用石川法求齿轮的啮合刚度，完整版的程序，里面可以运行啮合刚度图(Meshing Stiffness of Gears Calculated by Ishikawa Method)

cma盲均衡算法，适用于MPSK,低阶MQAM信号。()

IEEE802.15.4的opnet仿真模型源代码，主要解决无线传感器网络MAC层的接入问题协议。(The IEEE802.15.4 opnet simulation model of the source code, mainly on the MAC protocol.)

CAREL控制器通讯协议，通过这个文件即可编写自己carel控制器监控程序(CAREL DLL_LIBRARY32_2.1)