SRM-angles

时域分析 频域分析程序 GUI设计 数据是台架振动数据 (pretreatment of vibration signal)

对图像进行DCT正反变换，可以在matlab里面观察正变换后的数据，达到数据压缩。(DCT pros and transform the image in matlab which observed data is transformed to achieve data compression.)

利用MATLAB进行PID的仿真实验，调节参数可以分析出PID参数对系统的阶跃响应的影响。(The influence of PID parameters on the step response of the system can be analyzed by using MATLAB for PID simulation experiment. )

卷积码的编解码，译码采用维特比译码。编码包括zero-biting和tailing-biting两种方式。(Decoding convolutional codes, Viterbi decoding used. Code, including zero-biting and tailing-biting two ways.)

本代码是用来读取图像的，并把图像归入到一个矩阵中(This code is used to read the image and the image classified into a matrix)

presentation on controlling electronic devices using webcam

二维TE波圆柱FDTD的MATLAB仿真(Two dimensional TE wave cylindrical matlab simulation)

matlab detal ied introduction explantation lecture 3

To modify your build process, add your task inside one of the targets below and uncomment it

matlab 计算带驱动力偏微分方程poincare map，方程为dy(1)=y(2) dy(2)=-k*y(2)-y(1)^3+B*cos(t) (Matlab calculation of belt driving force of partial differential equation and Poincare map equation, Dy (1) =y (2) Dy (2) =-k*y (2)-y (1) ^3+B*cos (t) )