figure11

simulink basic firet order ode

，应用MATLAB仿真按序选择嵌入位的DCT变换算法，对仿真程序运行后的各种参数 和效果图的变化进行了分析；最后结合GUI开发设计出数字水印执行过程仿真控制界面，并用常见的水印攻击测试了该算 法的鲁棒性。(Application MATLAB simulation embedded spaces in sequence selection algorithm of DCT transform, simulation program running on the various parameters and the effect of changes in the map analysis Finally, the design of GUI development of the implementation of digital watermarking process simulation control interface, and common watermark attacks tested the robustness of the algorithm.)

The linearized model of a quadrotor about a 5 degree yaw angle in Simulink.

MATLAB基本应用领域基础教程Basic applications based on MATLAB Tutorial(The basis of the basic applications MATLAB Tutorial Basic applications based on MATLAB Tutorial)

这是一个单相并网逆变器双闭环控制，基于采用并网电流外环电容电流内环的方法对其进行稳定性控制，并实现有源阻尼控制。(This is a single-phase grid-connected inverter double closed-loop control, based on the use of parallel current loop capacitance current loop method to its stability control, and to achieve active damping control.)

桌面精灵设计报告，很好很完整的的设计文档！！！(桌面精灵设计报告，很好的设计文档！！！)

单载波频域均衡，迫零算法以及MMSE算法的比较(Single-carrier frequency domain equalizatio，compare zeros and MMSE )

用龙哥库塔方法求解积分，5阶龙格库塔方法(Method for solving integral with Long Ge Kuta, fifth-order Runge-Kutta method)

随机产生信息码求误码率 信息码长度（帧长64bit） 息码速率为10KHz（100us） 发送带宽20KHz（信息码速率的2倍） 发送信号功率2W 载波频率70MHz 采样频率280MHz（发送数据产生采样率） 20KHz方波 0KHz方波 0KHz方波高低电平采样点数 信息码采样点数 ASK调制的调制度ma=1-2/(2+alpha) 根据2ASK调制度确定alpha值(Random generation of information code for error rate 信息码长度（帧长64bit） Message length (64bit) 息码速率为10KHz（100us） The rate of interest rate is 10KHz (100US) 发送带宽20KHz（信息码速率的2倍） Transmission bandwidth 20KHz (2 times the rate of the information code) 发送信号功率2W Transmit signal power 2W 载波频率70MHz Carrier frequency 70MHz 采样频率280MHz（发送数据产生采样率） Sampling frequency 280MHz (transmit data generated sampling rate) 20KHz方波 20KHz Fang Bo 0KHz方波 0KHz Fang Bo 0KHz方波高低电平采样点数 0KHz square wave height sampling points 信息码采样点数 Information code sampling point ASK调制的调制度ma=1-2/(2+alpha) ASK modulation of the modulation system ma=1-2/ (2+alpha) 根据2ASK调制度确定alpha值 Determine the alpha value according to the 2ASK modulation system )

本文详细阐述了在matlab编程环境中如何进行数据拟合，非常详细的(This paper describes how in the matlab programming environment for data fitting, very detailed)