(EN_CN)SVM-Introduction-

Matlab program for some filters like wiener, median and wavelet.

OFDM Signal generation and decoding using 16-QAM .64QAM as the modulation technique. This type of OFDM is particularly useful for WiMAX and other Wireless and Multimedia Standards. Just run the Model and with different SNRs in the AWGN Channel Block observe the performance of the OFDM. (OFDM Signal generation and decoding using 16-QAM .64 QAM as the modulation technique. This type of OFDM is particularly useful for WiMAX and other Wireless and Multimedia Standards. Just run the Model and with different SNRs in the AWGN Channel Block observe the performance of the OFDM.)

PLS的修改算法，可以用于线性静态过程的故障诊断(partial least squares for fault diagnosis of static process)

有关matlab中simulink的应用，程序的编写和函数的建立(matlab simulink)

final long m Time Stamp = System.current Time Millis.

自适应LMS算法。由于我要使用，所以将信源信号及加澡后的信源信号保存起来。方便在FPGA设计里使用。(Adaptive LMS algorithm. Because I would like to use, so the source signal and add a noise after the shower saved the source signal. Designed to use in the FPGA.)

Matlab下UWB收发仿真,界面GUI画的(matlab UWB)

mobility and that can readily coexist with HSPA and earlier networks. OFDM/OFDMA technology is introduced for the LTE downlink, supporting very high data rates of up to 300Mbps while Single-Carrier FDMA (SC-FDMA) is used in the uplink with data rates of 80Mbps possible. Additionally, LTE supports operation both in paired and unpaired spectrum (FDD and TDD) using channel bandwidths of approximately 1.4MHz up to 20MHz. The frequency domain scheduling can be done in OFDMA. One of the main challenges in OFDMA is the high peak-to-average radio of the transmitted signal, which requires linearity in the transmitter. The linear amplifiers have low efficiency therefore, OFDMA is not an optimized solution for a mobile uplink where the

Smiths model simuation with autocorrelation as output

very important to understand tomography of medical MRI images