msk

绍了数字通信中的Q PSK 调制解调的原理和过程, 通过用M atlab 对这一过程的编程, 分析信号在 理想信道和加噪信道中模拟传输时的时域图, 并用蒙特卡罗方法, 讨论模拟过程中的误码率, 所得结果与理论 结果基本一致. 关键词:Q PSK 系统仿真 蒙特卡罗分析 M atlab(Shaozeng digital communications Q PSK modulation and demodulation principle and process, M atlab through the process of programming, analysis of signal processing in the ideal channel noise channel analog transmission of time-domain diagram, and Monte Carlo methods discussed in the process of simulation BER results are basically consistent with the theoretical results. Key words: Q PSK System Simulation Monte Carlo Analysis of M atlab)

说明：  已经验证过的64点FFT的Matlab源代码(64 points of FFT algorithm by been verified through matlab tool)

说明：  自己写的Canny算子的matlab实现和演示。程序虽然不大，但相信也能给大家一些参考。 (himself wrote the Canny Operator Matlab realization and demonstration. Procedures not much, but I believe that can give you some information.)

i got this code from some resource i edited ...

MATLAB BASED IMAGE ACQUISITION AND WHEELING CONTROL

Modeling of bldc with matlab

自收发光电检测，发射时间维持5ms左右，从PORT5读入光电接收管状态，不断进行自收发光电信号检测(zi receive light and )

蒙特卡洛仿真 运用蒙特卡罗方法建立随机仿真模型，对已做手术病人的出院时间进行模拟，从而得到第二天拟出院病人数。再根据一定的优先规则建立基于优先级的病床分配模型，确定第二天应该安排哪些病人住院。(Monte Carlo simulation)

本仿真是基于matlab的capon波束形成，包含3个仿真(The simulation is based on Matlab capon beamforming, contains three simulation)

电机矢量控制模型，控制参数可调，模型可改变成任何电机。(Motor vector control model, adjustable control parameters, the model can be changed to any motor.)