WindExample

自己编写12位DACTLV5616驱动程序头文件，验证成功。(I have written 12 DACTLV5616 driver header files, the validation is successful.)

说明：  (一) 设计交通灯控制的软硬件，实现交通灯的控制。 (二) 交通灯的红、绿、黄灯亮灯时间可以通过键盘设定。 (三) 交通灯控制要有直道、弯道及非机动车的通行、停止控制。 (四) 在某一方向通车或停车时，要有动态的指示，消除司机的烦躁情绪。 (五) 红灯停、绿灯行、黄灯停止未过线的机动车和停止方向的预启动。 (六) 黄灯亮的时间不可改变，预定5秒钟。 ((A) the traffic light control software and hardware design to realize the control of traffic lights. (B) the traffic lights red, green, yellow light time can be set via the keyboard. (C) of the traffic light control should be straight, curved and non-motor vehicle traffic, and stop control. (D) the direction of traffic or parking in a while, there must be a dynamic instructions, eliminating the driver' s irritable mood. (E) red light stop, green, and yellow lines to stop the vehicle has not been the direction of the pre-start and stop. (F) yellow light time can not be changed, scheduled for 5 seconds.)

关于电源一个c＋＋程序，里面有详细的英文说明；有需要的看看吧(on a c++ program, which has detailed descriptions in English; Need to see it)

单片机程序控制实现函数发生器的功能，在函数发生器中起主控制作用(SCM process control functions to achieve the function generator, function generator in the role play the main control)

积分器的一种实现方法：每级积分器都是一个反馈系数为1的单极点IIR滤波器, 其传递函数为:(An implementation of an integrator: each stage integrator is a single pole IIR filter with a feedback factor of 1:)

基于stm32单片机电压表设计,AD检测分压电阻电压值，根据电阻分压比算出所测电压，并显示在oled液晶上(Based on the design of voltage meter of STM32 single chip computer, AD detects the voltage value of dividing resistor, calculates the measured voltage according to the ratio of dividing resistor voltage, and displays it on OLED liquid crystal.)

单片机红外遥控系统 ，该文章详细的介绍了用单片机实现红外遥控。(SCM infrared remote control system, the article describes in detail the infrared remote control with MCU.)

C8051F350的UART0例程，很实用的简单例程。(The C8051F350 UART0 routine, very practical simple routines.)

关于c8051f350所有程序 (All programs on c8051f350)

说明：  NEC协议的红外遥控器解码程序，程序占用资源少，在51等单片机上验证OK。(ir decode for NEC protocal.)