Nashgame

用Matlab写的关于UDP（用户数据报协议）下的主机间的数据通讯。如需运行这个程序，只需把程序中的IP替换成你的主机IP地址即可(Written in Matlab data communication between host UDP (User Datagram Protocol). To run this program, simply replace the IP program into your host IP address can be)

收发传真，浏览传真的程序(A program which receive、send and scan fax)

16QAM信号最佳接收机，包括信号生成（+成型滤波）、上载波、过信道、下变频、匹配滤波、定时同步等过程(the optimal receiver for 16QAM, including signal source( shaped filter),modulation,AWGN channel, matched filter, timing sychnoization and so on)

matlab计算数据的AMR、ATR、RMS等特征值(calculate AMR and ATR of the data)

一份红外通讯的编码设计,已经经过实验，支持一对多。(Encoding of an infrared communication design, and after the experiment, to support one to many.)

线性调频信号的参数检测和估计原理方法，以及LFM信号的参数估计步骤(Linear FM signal parameter detection and estimation theory methods, and the LFM signal parameter estimation procedure)

温度报警系统程序，已经调试成功的，没有问题。(emperature alarm system program, has been successfully debugged, no problem.)

说明：  在实际的调谐解调电路中，采用的是非相干载波解调，本振信号与发射端的载波信号存在频率偏差和相位抖动，因而解调出来的模拟I、Q基带信号是带有载波误差的信号。这样的模拟基带信号即使采用定时准确的时钟进行取样判决，得到的数字信号也不是原来发射端的调制信号，误差的积累将导致抽样判决后的误码率增大，因此数字QPSK解调电路要对载波误差进行补偿，减少非相干载波解调带来的影响。(In the actual tuning and demodulating circuit, non-coherent carrier demodulation is adopted, and the frequency deviation and phase jitter of the local oscillator signal and the carrier signal of the transmitting end are present, and thus the demodulated analog I and Q baseband signals are signals with carrier error.)

在高斯白噪声信道下的误码率性能和误帧率仿真译码程序。(BPSK debugging in Gauss white noise channel)

说明：  STM32F103C8T6最小系统资料包。最小系统板资料，通用资料。(Minimum system board data, general information.)