BSS

现有的几个网络拓扑随机发生器，其实很难生成理想的网络拓扑结构，其主要原因在于很难控制节点的疏密和间距。我们提出来的这个改进算法，在随机抛撒节点的时候使用了K均值聚类，由本算法作为网络拓扑发生器，网络节点分布均匀且疏密得当，边的分布也比较均衡(The few existing random network topology generator, is in fact very difficult to generate the desired network topology, the main reason it is difficult to control the node density and spacing. We put forward the improved algorithm, throw in random nodes when using the K-means clustering, by the algorithm as a network topology generator, network nodes and spacing evenly distributed properly, the edge of a more balanced distribution of)

simulink based models

说明：  结构体中，批量数据的平滑，为进行模型拟合减少outlier，降低变异(in the structure ,smooth initial data )

互信息法求时间延迟，用于混沌方程的分析，采用matlab编写(mutual information for the time delay for the chaos equation analysis, prepared using Matlab)

基带信号周期采样的分析与仿真设计低通信号，对该信号进行周期采样，最后从采样数据中恢复原始信号；改变采样频率，给出相应的仿真结果；考察前端抗混叠滤波器的作用和必要性；分析后端理想恢复滤波器是否唯一。( Periodic sampling of the baseband signal analysis and simulation to design low pass signal, the signal is periodic sampling, finally recover the original signal from the sampled data changing the sampling frequency, gives the corresponding simulation results examine the front of the role of anti-aliasing filter and necessity analysis backend ideal restoration filter is unique.)

求解简单振动系统的响应（中心差分法，Wilson-θ法，Newmark-β法，Houbolt法）(Solving simple vibration response of the system (central difference method, Wilson-θ method, Newmark-β method, Houbolt method))

这个是用阶跃风速、风轮、传动系统以及转速控制器的模型，来观测风力发电机的阶跃相应(This step is to use the wind speed, wind turbines, transmission system and the model of the speed controller to measure wind generators step accordingly)

用MATLAB开发的BP算法源程序,对你或许有所帮助。(Developed using MATLAB source BP algorithm)

分类和拟合，支持向量新算法。最小二乘，但只能用于二维数据(Classification and fitting a new support vector algorithm. Least squares, but only for two-dimensional data)

直驱风电机组matlab/simulink仿真模型,很有用的风电仿真模型(Direct drive wind turbine simulation model matlab)