manish

采用专家PID设计控制器，实现三阶传递函数的阶跃响应(PID controller is designed by experts to achieve third-order transfer function of the step response)

matlab编程，matlab programming for enginners(matlab programming)

西储大学轴承数据，故障特征频率明显，与理论值基本符合。(The bearing data of Xichuan University have obvious fault characteristic frequency, which is basically in accordance with the theoretical value.)

很好的学习和理解OFDM的仿真代码，适合初学入门。作者为澳大利亚James Cook大学学生。(Good learning experience and understanding of the OFDM simulation code, suitable for beginners entry. The author is from Australian James Cook University.)

说明：  工作面采完后，地表沉陷曲面图利用MATLAB软件进行绘制-下沉曲面图和等值线图的绘制(Face after mining, surface subsidence surface Figure drawn using MATLAB software- sinking surface maps and contour mapping)

kummer 复函数实现合流超几何函数的matlab程序(kummer complex)

1．用Matlab产生正弦波,矩形波,以及白噪声信号，并显示各自时域波形图 2．进行FFT变换，显示各自频谱图，其中采样率，频率、数据长度自选 3．做出上述三种信号的均方根图谱,功率图谱,以及对数均方根图谱 4．用IFFT傅立叶反变换恢复信号，并显示恢复的正弦信号时域波形图(1. Produce sine wave, square wave, and the white noise signal with Matlab, and their time-domain waveform display 2. FFT transform, display each spectrum, where the sampling rate, frequency, length optional data 3. RMS to make maps of the three signals, power spectrum, as well as the number of RMS map 4. Restored by inverse Fourier transform IFFT signal and displays the time domain waveforms sinusoidal signal recovery)

说明：  基于离散趋近率的滑模变结构控制MATLAB程序(Based on the convergence rate of discrete sliding mode variable structure control MATLAB program)

BPSK基带传输系统的MATLAB仿真 实现了主要模块二进制信息源输入，BPSK调制，发射滤波器，接收滤波器，采样，均衡，信号检测，BPSK解调，信息还原输出，产生BER曲线图。 (failed to translate)

LTE频分双工模式下的上行信道探测的MATLAB代码，实现上行信道的探测。(The SRS matlab code of the up_link of FDD-LTE .)