-
mitmatlab
说明: 数据挖掘中经典算法的matlab代码,相当全面!(Classical data mining algorithm matlab code, quite comprehensive!)
- 2008-09-22 14:46:24下载
- 积分:1
-
dstatcom
A static synchronous compensator (STATCOM), also known as a "static synchronous condenser" ("STATCON"), is a regulating device used on alternating current electricity matlab simulink
- 2013-10-14 20:04:45下载
- 积分:1
-
dsp-1
Generation of a Signals
- 2014-12-04 23:29:49下载
- 积分:1
-
73325228-05-Reporte-Reduccion-de-diagrama-de-bloq
MATLAB DIAGRAMAS N BLOQUES
- 2013-05-08 16:51:24下载
- 积分:1
-
cal-sin
matlab程序实例WORD版,计算三角函数实例,初学者可以看一下
(Examples WORD version matlab program to calculate trigonometric examples, beginners can look at)
- 2013-05-27 10:21:41下载
- 积分:1
-
filteredGN
滤波器高斯噪声信道模型,信道模型的一种,matlab仿真源码(Filtered Gaussian Noise Model matlab code)
- 2014-01-03 16:23:40下载
- 积分:1
-
免疫遗传算法的改进粒子滤波算法
基于免疫遗传算法的改进粒子滤波算法效果可行(The effect of the improved particle filter algorithm based on immune genetic algorithm is feasible)
- 2020-07-04 03:40:02下载
- 积分:1
-
1
说明: 用fir滤波器消除语音信号中50Hz的工频信号,matlab程序(Using fir filter to eliminate the voice signal in the 50Hz frequency signal, matlab program)
- 2017-05-03 14:45:53下载
- 积分:1
-
项目4
说明: 任务:设计一个4×2.5Gbit/s 长距离光纤传输系统,并利用OptiSystem 仿真验证。
要求:
1.采用波分复用技术,波长设置以100GHz 为间隔,频率分别为193.1THz、193.2THz、193.3THz、193.4THz,每个波长传输速率为2.5Gbit/s(NRZ),传输距离为300km。采用常规光纤,光纤损耗系数为0.25dB/km。
2.单通道光发送机最大输出功率为0dBm,光接收机的接收光功率不低于-26dBm,过载点为-10dBm。
3.可以采用EDFA 作为线路放大器,其中EDFA 的输入功率限制在-18~2dBm,最大输出功率20dBm,增益范围为13~25dB,噪声指数4.0dB。(Task: Design a 4 x 2.5 Gbit/s long-distance optical fiber transmission system, and use OptiSystem simulation to verify.
Requirement:
1. Using wavelength division multiplexing technology, the wavelength is set at 100GHz intervals, with frequencies of 193.1 THz, 193.2 THz, 193.3 THz and 193.4 THz, respectively. The transmission rate of each wavelength is 2.5 Gbit/s (NRZ), and the transmission distance is 300 km. The loss coefficient of conventional optical fibers is 0.25dB/km.
2. The maximum output power of a single-channel optical transmitter is 0 dBm, and the receiving power of an optical receiver is not less than -26 dBm, and the overload point is -10 dBm.
3. EDFA can be used as line amplifier, where the input power of EDFA is limited to - 18-2dBm, the maximum output power is 20dBm, the gain range is 13-25dB, and the noise index is 4.0dB.)
- 2019-05-13 09:39:41下载
- 积分:1
-
KalmFilter
说明: 一些有关卡尔曼滤波器的资料,非常全面,对关卡尔曼滤波器的原理用法都有详细的介绍(Some of the Kalman filter the information, very comprehensive, right off the principle of use of the Kalman filter are introduced in detail)
- 2010-03-21 21:29:21下载
- 积分:1