FDTDMatlab

matlab code for seismic Migration

These are matlab codes for cfd applications

本书重点介绍matlab在数字信号处理中的基本应用及编程方法。(this book mainly introduce the basic application of MATLAB in DSP field)

ICALAB for Signal Processing Toolbox for BSS, ICA, cICA, ICA-R, SCA and MCA

基于二阶和高阶统计量的MIMO系统盲信道估计，可完美进行信道估计，进行误码率及误差分析等。(Based on second-order and higher-order statistics of the MIMO system, blind channel estimation can be the perfect channel estimation carried out for the bit error rate and error analysis.)

说明：  这是一个matlab编写的哈米德能量理论研究的一个程序，文章发表在微型计算机杂志上可以作为参考(This is a matlab energy Hamid prepared a program of theoretical research, the article published in the Journal of micro-computer can be used as reference)

mimo folder is this one , goood to help u

exresice of marcel sidi

说明：  根据前人研究成果可以证明，煤镜质组反射率各向异性对煤田构造特征具有指示意义，镜质组最小反射率可以指示构造主应力方向。然而，在实际测量中，如何得到真正的镜质组最大、最小反射率及其方位是其中的关键环节。利用现有的岩石有限应变椭球拟合方法进行镜质组反射率椭球体拟合不失为一种行之有效的方法，可以由此确定镜质组最大、最小、中间反射率及其三维空间方位。 将之前拟合得到的反射率椭圆看作岩石有限应变椭圆即二维应变，其由之前的统计方法测定得到，三个截面的数据对于拟合唯一应变椭球来说是过多的，因此不可避免出现误差，导致三个截面应变椭圆不通过同一个椭球的情况。为了从三个截面数据得到唯一的应变椭球，需要对得到的数据进行相容性调整。采用Oertel的方法，从每一测量参数在不同截面中的值是正态分布这一假定出发，利用加权最小二乘法进行误差调整。(According to results of previous studies may prove vitrinite reflectance anisotropy on structural characteristics have implications for coal, vitrinite reflectance may indicate tectonic minimum principal stress directions. However, in actual measurement, how to get real vitrinite maximum, minimum reflectivity and its orientation is the key link. Conduct vitrinite reflectance ellipsoid fitting regarded as a proven method using existing rock finite strain ellipsoid fitting method can thus determine vitrinite maximum, minimum, intermediate reflectance and dimensional spatial orientation . Before fitting the reflectance of finite strain ellipse oval rock that is seen as a two-dimensional strain, as determined by statistical methods which have been before the data fit only for the three sections of the strain ellipsoid is excessive, and therefore can not to avoid errors, resulting in three elliptical cross-section does not pass through the same strain ellipsoid situation. In order to obtai)

simulink file for direct analog frequency sinthesys