DWT

程序代码说明 P0610：神经网络的实例(Procedure Code Description P0610: examples of neural network)

薛定宇写的控制系统计算机辅助设计这本书上一段程序，是关于BPpid的s函数程序(Computer aided Design of Control system written by Xue Dingyu A program in this book is about BPpid s function program)

完整的OFDM仿真程序，在matlab上运行。有详细的解释。(Complete OFDM simulation program, run in matlab. A detailed explanation.)

MATLAB-stat，this is a programme for matlab

自己用Matlab写的FFT的代码，主要是为了FPGA实现的前期建模(FFT using Matlab to write their own code, mainly to preliminary modeling of FPGA implementation)

极坐标法的matlab程序，采用了N-R算法(Polar coordinate method matlab program)

利用粒子滤波器完成故障诊断，特别是不完备的情况中故障诊断。(particle filters for the fault diagnosis, especially incomplete fault diagnosis.)

各种PID控制算法的MATLAB源程序，可以结合相应的指导书学习(various PID control algorithm MATLAB source, combining the corresponding study guide book)

对正交频分复用的仿真，主要针对其简单原理进行仿真(On orthogonal frequency division multiplexing of the simulation, the main principle for its simple simulation)

fasica 独立成分分析MATLAB程序(fastica independent component analysis)