Wind-with-Induction

说明：  海平面数模程序——针对国际赛的一个题目，很好很实在(Sea-level digital-analog process- a topic for international competitions)

结构动力学有限元计算，基于MATLAB梁单元分析方法(beam fe analysis)

说明：  任务：设计一个4×2.5Gbit/s 长距离光纤传输系统，并利用OptiSystem 仿真验证。 要求： 1．采用波分复用技术，波长设置以100GHz 为间隔，频率分别为193.1THz、193.2THz、193.3THz、193.4THz，每个波长传输速率为2.5Gbit/s（NRZ），传输距离为300km。采用常规光纤，光纤损耗系数为0.25dB/km。 2．单通道光发送机最大输出功率为0dBm，光接收机的接收光功率不低于－26dBm，过载点为－10dBm。 3．可以采用EDFA 作为线路放大器，其中EDFA 的输入功率限制在－18～2dBm，最大输出功率20dBm，增益范围为13～25dB，噪声指数4.0dB。(Task: Design a 4 x 2.5 Gbit/s long-distance optical fiber transmission system, and use OptiSystem simulation to verify. Requirement: 1. Using wavelength division multiplexing technology, the wavelength is set at 100GHz intervals, with frequencies of 193.1 THz, 193.2 THz, 193.3 THz and 193.4 THz, respectively. The transmission rate of each wavelength is 2.5 Gbit/s (NRZ), and the transmission distance is 300 km. The loss coefficient of conventional optical fibers is 0.25dB/km. 2. The maximum output power of a single-channel optical transmitter is 0 dBm, and the receiving power of an optical receiver is not less than -26 dBm, and the overload point is -10 dBm. 3. EDFA can be used as line amplifier, where the input power of EDFA is limited to - 18-2dBm, the maximum output power is 20dBm, the gain range is 13-25dB, and the noise index is 4.0dB.)

Solving ODEs with Matlab Instructors Manual

prmlmatlab各章算法程序的编写，这些程序是各大名校的大牛人认真编写，给我们学习MATLAB有很大帮助(prmlmatlab algorithm procedures for the preparation of each chapter, these programs are the major schools of large cattle carefully prepared, give us great help to learn MATLAB)

Sparse matrix storage and computing

机器人编队仿真程序，采用人工势场法，可以实现编队，避障等功能。(Robot formation simulation program)

南邮光电综合设计第二组程序，希望大家有用，谢谢(so big)

for MLP neural network.

simulink简明教程，初步了解simulink的使用方式(simulink simple tutorial a preliminary understanding of the usage simulink)