RSSI-positioning-algorithm-matlab

用matlab实现主元分析的故障诊断，在我的硕士论文中具有分析性(Using matlab to achieve the principal component analysis, fault diagnosis, and analytical in my Master' s thesis)

Mysmo.mdl 永磁同步电机的主程序，可以实现有速度传感器启动运行，和无速度传感器运行。 SMOmodel.m 改进的滑模观测器模型，实现永磁同步电机反电动势的估算。 PFCDCM0hm5 用的是0.5hm的电感，实现220V交流电变换成400V的直流电，电流断续。 由于是仿真，如果要硬件实现的话，除了需要电压采样外，还需要一个输入电压过零检测 PFCCM320percent98k50 用的是5hm的电感，实现220V交流电变换成320V的直流电，电流连续。功率因数可以达到0.98，用的开关频率为50K PFCCM400percent97k50.mdl 用的是5hm的电感，实现220V交流电变换成400V的直流电，电流连续。功率因数可以达到0.97，用的开关频率为50K (Permanent magnet synchronous motor Mysmo.mdl main program, you can achieve the speed sensor up and running, and speed sensors run. SMOmodel.m improved sliding mode observer model permanent magnet synchronous motor back-EMF estimates. PFCDCM0hm5 with is 0.5hm inductor to achieve 220V AC transform into a 400V DC current is interrupted. As the simulation, hardware implementation, then, in addition to the voltage sampling an input voltage over zero detection PFCCM320percent98k50 the is 5hm inductance to achieve transformation 220V AC 320V DC continuous current. The power factor can reach 0.98, the switching frequency for 50K PFCCM400percent97k50.mdl with is 5hm inductance 220V AC transform 400V DC continuous current. The power factor can reach 0.97, with the switching frequency is 50K)

角点检测算法代码 已经验证过，无误 哦哦哦。。(Corner detection algorithm code has been proven correct oh. .)

用matlab编写的平方根容积卡尔曼滤波器，经试验验证可用，(The square root volume using matlab Kalman filter, the experimental verification is available,)

ORC matlaab program v2.0

这是一些关于matlab基础的教程 初学者可迅速掌握上手(Matlab based tutorial for beginners to master to get started quickly)

fuzzy identification

TurboMatlabSimulation_3GPP_Std，基于mac层仿真，详尽的turbo编解码程序(TurboMatlabSimulation_3GPP_Std, based mac layer simulation, detailed turbo codec)

matlab绘制阵列正六边形。采用角度方法。(Draw a regular hexagon array matlab. Using the angle method.)

作业：Nomoto 数学模型 model on MATLAB(homework: Nomoto mathematical model on MATLAB)