Trangular-Method-For-Camera-Calibration

park transformation using simulink blocks

本程序是计算振动信号各种参数的实验程序。 主要功能是计算均值、标准差、方差、偏斜度、峭度、 峰峰值、方根幅值、平均幅值、峰值、 波形指标、峰值指标、脉冲指标、裕度指标。 (matlab index)

Matlab function to apply Gabor filter to an image.

说明：  一个基于MATLAB的生物芯片数据分析包(MATLAB-based data analysis of the bio-chip package)

SourceCode For Find Path in Robot

分前后两级，前级boost升压电路，后级三相全桥逆变(Points before and after the two pre-boost boost circuit, after three-phase full-bridge inverter)

icp算法源代码，主要用于点云拼合，是基于matlab上编写的,实现两个点云数据的对准(ICP algorithm source code, mainly used for point cloud registration, is prepared based on MATLAB, the realization of the two point cloud data alignment )

Rice大学开发的可用于二维图像压缩感知的算法TVAL3，matlab代码，可在demo中替换二维图像后直接运行(Run directly after the two-dimensional image can be used for compressed sensing algorithm TVAL3 Rice University developed, matlab code, you can replace the two-dimensional image in demo)

说明：  三维坐标系下的比例导引拦截目标，目标为正弦函数波动。(Interception Target by Proportional Guidance in Three-Dimensional Coordinate System)

这是同步电机，在dq0坐标下建立的空载建立电压的仿真模型，用sumilink实现的(This is synchronous motor, set up at dq0 coordinates of the no-load voltage set up the simulation model, using the implementation sumilink)