duandianshizhong

飞特机器人资料，包含机器人以及舵机驱动程序，keil驱动代码(Flight Robot Data Flight Robot Information, including Robot and Actuator Driver, Keil Driver Code)

该程序实现了用单片机来控制时钟芯片DS1302进行万年历的显示。 这个代码相对来说很复杂，注释比较多。 程序运行，首先设置时间。 按S19，进行某一位的设置，会看到某一位上面会闪烁。 按S20，数值加1. 按S21，数值减1. 设置完后，时间会进行运行。 另外,1602上也会有时间显示的。(The program implements the MCU to control the clock chip DS1302 conducted calendar display. This code is relatively complex, comment more, we can carefully analyzed. The program runs, the first set the time. By S19, conducted a one set, you will see a bit above flashes. By S20, the value plus 1. By S21, the value minus 1. After setting, the time will be run. Further, the time will be displayed in 1602.)

基于IAR开发环境，野火FTM 配置文件，包含C和H文件(Based on the IAR development environment, wildfire FTM configuration file, including C and H files)

基于VC++6.0应用MSCOMM控件的串口通信上位机程序,实现与51单片机的通信(Based on VC++ 6.0 Application MSCOMM control PC serial communication procedures, with 51 single-chip communication)

DS18B20多IO驱动，带有滤波，数据更稳定精确(DS18B20 driver, with filtering, more stable and accurate data)

说明：  基于stm32f103读取温度数值,DHT11通过液晶显示读取温度(I am very happy to provide you with this information. I wish you success in your studies)

stm32和7714之间的SPI调试程序，已经成功可以使用(The SPI debugger between STM32 and 7714 has been successfully used.)

说明：  DS1302andLCD1602,danpianji

该程序是CRC校验程序，可以查看文件的校验和，这对文件本身进行校验，也可用在其它程序中检难数据正确与否(CRC procedures can view the document and check that the document itself calibration, but also can be used in other programs Frederick hard data are correct or not)

51控制的8x8x8光立方（512个LED的亮灭），变成实现不同的团变化，采用不同的延时时间是转换的速度不同。完整的源程序，电路图和PCB(51 controls the 8x8x8 cube of light (512 LED light off), to achieve different changes into groups with different delay times are different conversion speeds. Complete source code, schematics and PCB)