TCM

1-32是：图形应用篇 33-66是：界面设计篇 67-84是：图形处理篇 85-100是：数值分析篇(1-32 is: graphics application papers 33-66 are: interface design articles 67-84 is: graphics processing chapter 85-100 is: Numerical Analysis Section)

Circles We can extend the Hough transform to other shapes that can be expressed parametrically. For example, a circle of fixed radius can be described fully by the location of its center (x, y). Think of each feature (edge) point on the circle as saying, ”if I’m on the circle, the center must be in one of these places”. It turns out that the locus of these votes is itself a circle. But what about circles of unknown size? In this case, we need a third parameter: the radius of the circle. So, we can parameterize circles of arbitrary size by (x, y, r). Instead of casting votes in a circular pattern into a two-dimensional accumulator, we cast votes in circles of successively larger size in a three-dimensional accumulator.

不考虑运行约束的关于电力系统SG交流潮流程序(Running constraints not consider on AC power system SG trend program)

matlab数字水印 通过这个程序可以给原图象加上水印 但不可以提取！(a watermark sourcecode implemented by MATLAB. By using this program, primary image can be embedded while the watermark cannot be extracted.)

信息论的内容定义以及信息的传输过程和噪声的加入使得信息的传输的影响(Information Theory)

活套解耦控制matlab仿真，供写论文使用(Decoupling control loop matlab simulation, for the use of writing a paper)

电力系统潮流计算程序，适用于电力系统常规潮流分布计算(power system power flow caculation...)

signal ecg processing

matlab遗传工具箱及应用的源码，适合初学者学习(Matlab genetic toolbox and its application)

STATE FEEDBACK CONTROLLER USING POLE PLACEMENT TECHNIQUE