testface

分别采用RGB模型和HIS模型对图像imageLane.bmp进行平滑和锐化，并比较两种模型处理后结果是否相同(RGB model and HIS were used to model the image imageLane.bmp for smoothing and sharpening, and compare the results of the two models are the same after)

两个16个阵元的平面阵波束形成。很好用的(16 element array of two plane array beamforming. Very good use)

说明：  matlab程序读取EXCELL格式的数据，感觉好的话，就顶一下，程序可用(matlab program to read Excel data format, I feel good, look on the roof, procedures available)

说明：  Genetic Algorithm(GA) by MATLAB

matlab进行TCP、UDP通信的例子，使用Instrument Control Toolbox(TCP and UDP Communication Example for matlab using Instrument Control Toolbox)

说明：  对线性调频信号用dft方法分频后进行窄带波束形成后拼接，为宽带波束形成方法(After dividing the frequency of LFM signal by DFT method, narrow-band beamforming and splicing are used as the broadband beamforming method.)

一个混沌保密通信的simulink模型，效果很好(A chaotic secure communication of the simulink model, the effect of good)

PCA for image compression, Sanger s algorithm implemented with neural networks

基于MATLAB的语音信号处理，实现对语音信号的时频分析，加噪滤波处理等等(Speech signal processing)

The overall objective for LTE is to provide an extremely high performance radio-access technology that offers full vehicular speed mobility and that can readily coexist with HSPA and earlier networks. OFDM/OFDMA technology is introduced for the LTE downlink, supporting very high data rates of up to 300Mbps while Single-Carrier FDMA (SC-FDMA) is used in the uplink with data rates of 80Mbps possible. Additionally, LTE supports operation both in paired and unpaired spectrum (FDD and TDD) using channel bandwidths of approximately 1.4MHz up to 20MHz. The frequency domain scheduling can be done in OFDMA. One of the main challenges in OFDMA is the high peak-to-average radio of the transmitted signal, which requires linearity in the transmitter. The linear amplifiers have low efficiency therefore, OFDMA is not an optimized solution for a mobile uplink where the