MIMO_OFDM_MATLAB_program

模式识别工具箱 包含大部分duda的《pattern classification》的习题程序(pattern recognition toolbox)

FFT程序，在做OFDM时是必要的模块，很有用，在matlab上仿真实现。(FFT program, is necessary when doing OFDM module useful in matlab Simulation. )

利用matlab对机器人避障进行仿真研究的一个小程序(Simulation of the robot obstacle avoidance)

使用模糊自适应主动控制飞机起落架振动阻尼的研究(Using fuzzy adaptive active control landing gear vibration damping research)

用于根据切削原理生成螺旋锥齿轮齿面散点。(Used to generate helical bevel gear tooth surface scatter according to the cutting principle.)

这是一个速率为2的mimo系统，希望大家有用(This is a rate of 2 MIMO system, hope that useful)

一、 本程序采用16QAM调制方式，对一串2进制信源进行调制，采用（7，4）循环码对信源做信道编码，用升余弦滚降函数进行基带调制，再调到高频信道；在信道上加入高斯白噪声，运用匹配滤波器解调，画出解调星座图，运用最小欧氏距离译码判决，再对信号进行信道解码，画出采用信道编码技术和不采用信道编码技术的误比特率图。(First, this program uses 16QAM modulation mode, for a string of two binary source is modulated, using (7,4) cyclic code of the source-channel coding to do with a raised cosine roll-off function for base-band modulation, and then transferred to a high frequency channel in the channel by adding Gaussian white noise, the use of matched filter demodulation, demodulation constellation plot, using the minimum Euclidean distance decoding decision, and then right channel signals, decoding, channel coding techniques used to draw and non- channel coding techniques using bit error rate plans.)

系统辨识与MATLAB举例说明 国防科技大学(MATLAB system identification example, the National Defense University)

matlab的主要编程的函数命令,简洁明了,适合初学者!(matlab a function of the main programming command, concise, suitable for beginners!)

homography calculation by using the DLT method