ant

三相短路计算程序 模拟发电机机端三相短路仿真(san xiang duan lu)

用于结构在动力荷载作用下的时程分析,地震荷载，随即荷载均可，采用newmark方法(For structural time history analysis under dynamic loads, seismic loading, then the load can be, using the newmark method)

能量和过零率的计算程序 能量和过零率的计算程序(ampzcr.m － 能量和过零率的计算程序 ampzcr.m － 能量和过零率的计算程序)

说明：  6QAM通过带限信道，设码元速率为1000波特，传输信道特性为滚降系数为0.75的滚升余弦频谱的滤波器，试建立测试模型并观察接收信号（等效基带信号）的眼图、星座图和相位转移轨迹图。simulink模型(6QAM through the band-limited channel, located at 1000 baud symbol rate, the transmission channel characteristics for the roll-off factor of 0.75 of spectrum raised cosine filter roll and try to create a test model and observe the received signal (the equivalent baseband signal) of the eye diagram, constellation and phase transfer trajectories. simulink model)

matlab常用函数表，对于初学者，真的很有帮助哦(matlab function table used for beginners, really helpful oh)

对数据进行reof处理，得到数据的空间模态和时间系数(Matlab function of reof)

经验模态分解，依据数据自身的时间尺度特征来进行信号分解，给出本征函数。(Empirical mode decomposition, based on the data itself characteristic time scale for signal decomposition, given the intrinsic function.)

根据所给样本数据用三种不同的方法绘制该公路并估计其长度。 分别用线性插值法、最近邻域插值法和三次样条插值法计算公路长度，并用勾股定理估计公路的长度 (According to the sample data in three different ways, the road map and estimate its length. , Respectively, by linear interpolation, nearest neighbor interpolation domain and cubic spline interpolation method to calculate the length of highways and roads with an estimated length of Pythagorean Theorem)

计算单模光纤的色散曲线，最后拟合出色散随波长变化的曲线(Single-mode fiber dispersion curve calculation, the final fitting with excellent wavelength dispersion curve)

说明：  用matlab写的一个关于高斯图像加噪声算法的实现(Using matlab to write an image plus noise on the Gaussian Algorithm)