MATLAB-temperature-flied

这个程序针对的问题是: 17个人为成圈,依次编号为0-16,从第一号开始报数,报到3的倍数的人离开, 一直数下去,直到最后只剩1人,求此人的编号. 程序有点复杂，不过还只能算是初级的水平 (This procedure for the question is: 17 individuals into the circle, followed by numbered 0-16, from the first to begin reported the number of people who report a multiple of three to leave, to keep counting votes until the last only a person seeking this person number. program a bit complicated, but can only be considered the primary level of)

图像中光点坐标定位的matlab程序及位置坐标数据(image processing)

用C语言编写MATLAB 函数， 以用于DSP芯片上(Use the programming language C to write MATLAB function, col2im )

Simple precoding and decomosition fuction

1．用Matlab产生正弦波,矩形波,以及白噪声信号，并显示各自时域波形图 2．进行FFT变换，显示各自频谱图，其中采样率，频率、数据长度自选 3．做出上述三种信号的均方根图谱,功率图谱,以及对数均方根图谱 4．用IFFT傅立叶反变换恢复信号，并显示恢复的正弦信号时域波形图(1. Produce sine wave, square wave, and the white noise signal with Matlab, and their time-domain waveform display 2. FFT transform, display each spectrum, where the sampling rate, frequency, length optional data 3. RMS to make maps of the three signals, power spectrum, as well as the number of RMS map 4. Restored by inverse Fourier transform IFFT signal and displays the time domain waveforms sinusoidal signal recovery)

这是我用插入法编的，绝对高效。没事可以试试，非常好用。(This is my code with the Insert method, the absolute efficiency. Nothing can try, very easy to use.)

由matlab仿真的,超宽带信号中估计带宽程序(By matlab simulation, ultra-wideband signal bandwidth procedure estimated)

matlab 倒立摆PID、LQR仿真程序(matlab Handstand pendulum simulation, using PID，LQR control)

MATLAB的PLC仿真与研究文档，非常全！(MATLAB the PLC simulation study of documents, very full!)

相控阵天线中,对各个子阵的幅度加权不同达到降低旁瓣的目的，本程序是子阵加权（taylor）程序(The phased array antenna, for each sub array amplitude weighting of different reduce sidelobe purpose, this procedure is the subarray weighting (Taylor) program)