登录
首页 » matlab » Q_DSSS

Q_DSSS

于 2009-03-02 发布 文件大小:5KB
0 380
下载积分: 1 下载次数: 143

代码说明:

  直扩码分多址DS-CDMA是利用高速的WALSH正交码序列作为地址码,与多用户信息数据相乘得到信息数据的直接扩频信号,再经过BPSK调制后发送出去,经过AWGN无线信道的传输后,在接收端与本地产生的地址码进行相关检测,从中将地址码与本地码一致的用户数据选出,把不一致的用户数据删除。(DS-CDMA DS-CDMA is the use of high-speed WALSH orthogonal code sequences as address code, with multi-user information data has been multiplied by the direct spread spectrum data information signal, and then after a BPSK modulated sent through AWGN channel after transmission, at the receiving end with the locally generated address code associated Detect, which will address code with local codes consistent user data elected to delete user data inconsistencies.)

文件列表:

Q_DSSS
......\awgn.m
......\BPSK_AWGN_Pe.m
......\DSSS_Demodulation.m
......\DSSS_Main.asv
......\DSSS_Main.m
......\DSSS_Modulation.m
......\SignalEncode.m

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • BTBook-(1)
    This is book about bluetooth programming and other items. Is good for beginerss.
    2014-02-22 01:07:18下载
    积分:1
  • time_varying_multipath_channel
    说明:  单频信号经过多径时变信道后,输出信号的包络随时间随机起伏,输出信号的频谱从冲激谱变成一个窄带频谱。径数位20,变化频率从0—2HZ随机均匀抽取。(Single-frequency signal through time-varying multipath channel, the output signal envelope random fluctuations over time, the output signal from the impulse of the spectrum into a narrow-band spectrum spectrum. Digital Drive 20, changes in frequency from 0-2HZ uniform random samples.)
    2009-08-22 19:18:56下载
    积分:1
  • VCMatlab
    VC++和 Matlab 的 混 合 编 程 具 有 很 大 的 实际意义。 文 讨 论 了如何 使 用 Matlab 的 Complier 将 *.m 函 数 编 译 为 动 态 链 接 库 DLL, 提 供 给 VC++调 用 的 方 法,提 供 了 一 种 VC++与 Matlab 混合编程的 快 速 实 现 。(The mixed programming of VC++ and Matlab has great practical significance. This paper discusses how to use COMplier of MATLAB to compile *. m function into DLL of dynamic link library and provide a method for calling VC++. It also provides a fast realization of mixed programming between VC++ and MATLAB.)
    2018-12-01 15:31:19下载
    积分:1
  • MIMO信道代码
    一段MIMO信道matlab源代码,适合论文仿真编程(A MIMO channel matlab source code, suitable for the simulation programming)
    2021-04-15 20:38:54下载
    积分:1
  • IIR
    使用matlab实现设计IIR滤波器:冲激不变法、双线性变换法 设计一个巴特沃思低通滤波器,其技术指标为:3dB带宽为,阻带截止频率为,阻带衰减大于30dB,采样间隔T=10us。 1)用冲激响应不变法 2)用双线性变换法设计 3)用FIR的矩形窗函数设计 二、用双线性变换法分别设计低通、高通、带通、带阻四种滤波器。模拟滤波器带原型分别为切比雪夫滤波器和椭圆滤波器,采样率Fs=20kHz,指标如下: 1)低通:通带0~4 kHz,阻带5 kHz,通带衰减Rp=0.5dB,阻带衰减As=10dB。 2)高通:阻带0~4 kHz,通带5 kHz,通带衰减Rp=0.5dB,阻带衰减As=10dB。 3)带通:通带2kHz~4 kHz,阻带0~1.5 kHz,4.5kHz以上,通带衰减Rp=0.5dB,阻带衰减As=10dB。 4)带阻:阻带2kHz~4 kHz,通带0~1.5 kHz,4.5kHz以上,通带衰减Rp=0.5dB,阻带衰减As=10dB。(Using MATLAB to implement the design of IIR filters: impulse invariant and bilinear transformation)
    2018-01-06 15:19:26下载
    积分:1
  • LFM
    用MATLAB产生线性跳频信号,中心频率和带宽可调(Using MATLAB to generate linear frequency hopping signal with adjustable center frequency and bandwidth)
    2020-08-27 10:08:13下载
    积分:1
  • sd模型
    完整的Verilog验证模型,包括设备完整的状态。(Complete verilog Verification Model)
    2020-06-16 09:00:01下载
    积分:1
  • QPSK-ALL
    简单的MIMO模拟 假定QPSK,ML解码(SM ZF检测器除外)。 mrc.m - 最大比例组合 stc.m - 具有1和2个接收天线的Alamouti空时分组码 bf.m - 特征波束形成 sm.m - 空间复用2x2(ML解码和次优逼迫) 简单的OFDM仿真 模拟保护带,用于信道估计的循环前缀前导码符号(Simple MIMO simulations Assumes QPSK, ML decoding (except SM ZF detector). mrc.m - maximal ratio combining stc.m - Alamouti space-time block code with 1 and 2 receive antennas bf.m - Eigen-beamforming sm.m - Spatial multiplexing 2x2 (both ML decoding and suboptimal zero forcing) Simple OFDM simulation Simulates guard band, cylic prefix Preamble symbol used for channel estimation)
    2018-04-18 22:39:33下载
    积分:1
  • 8b10b Verilog
    采用verilog语言基于查找表描述8b10b编码源代码(Using Verilog language to describe 8B10B encoding source code based on look-up table)
    2021-01-27 14:58:41下载
    积分:1
  • dianhua
    用与电话和电脑的串行通讯,用的是VB写的一些介绍和实例(Used with the telephone and computer serial communications, using VB to write the introduction and examples of some)
    2008-05-27 15:17:58下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载