mw11111

基于近邻法的相关MATLAB实验方法，课件。，(Based on the MATLAB nearest-neighbor method clip algorithm experiment, the source code, and data analysis )

用matlab编程，实现了资源调度算法。(With the matlab programming,it can solve resource scheduling algorithm。)

说明：  任务：设计一个4×2.5Gbit/s 长距离光纤传输系统，并利用OptiSystem 仿真验证。 要求： 1．采用波分复用技术，波长设置以100GHz 为间隔，频率分别为193.1THz、193.2THz、193.3THz、193.4THz，每个波长传输速率为2.5Gbit/s（NRZ），传输距离为300km。采用常规光纤，光纤损耗系数为0.25dB/km。 2．单通道光发送机最大输出功率为0dBm，光接收机的接收光功率不低于－26dBm，过载点为－10dBm。 3．可以采用EDFA 作为线路放大器，其中EDFA 的输入功率限制在－18～2dBm，最大输出功率20dBm，增益范围为13～25dB，噪声指数4.0dB。(Task: Design a 4 x 2.5 Gbit/s long-distance optical fiber transmission system, and use OptiSystem simulation to verify. Requirement: 1. Using wavelength division multiplexing technology, the wavelength is set at 100GHz intervals, with frequencies of 193.1 THz, 193.2 THz, 193.3 THz and 193.4 THz, respectively. The transmission rate of each wavelength is 2.5 Gbit/s (NRZ), and the transmission distance is 300 km. The loss coefficient of conventional optical fibers is 0.25dB/km. 2. The maximum output power of a single-channel optical transmitter is 0 dBm, and the receiving power of an optical receiver is not less than -26 dBm, and the overload point is -10 dBm. 3. EDFA can be used as line amplifier, where the input power of EDFA is limited to - 18-2dBm, the maximum output power is 20dBm, the gain range is 13-25dB, and the noise index is 4.0dB.)

CACC和CAIM_算法函数库，MATLAB版本(CACC and CAIM_)

一个pi/4-DQPSK的仿真程序，GUI界面，可以计算误码率(a pi/4-DQPSK simulation program, GUI interface, the error rate can be calculated)

OFDM Rayleigh simulation

MIT的一个工具箱，可以看看，觉得还可以(a toolbox can see, I felt that I could)

颗粒提取，用于MATLAB仿真的，提取一些细小的颗粒。效果较好。(Particle extraction for the MATLAB simulation, extract some small particles. Better.)

1-D信号压缩传感的实现(正交匹配追踪法Orthogonal Matching Pursuit)(Orthogonal Matching Pursuit inCS)

the encoder and decoder of Linear block code