SPLBASE

一个简单介绍如何使用Matlab生成HDL代码，如何让使用Matlab和Modlsim联合仿真(A brief introduction how to use the Matlab generated HDL code, and how to make co-simulation using Matlab and the Modlsim)

用matlab求框架的位移，多自由度发，有限元素(Frame------p73 example2.8 Yijun Liu Introduction to FEM & Frequencies calculation)

matlab编写的对灰度图像进行去噪处理，共有三种方法，最后可以计算去噪后的均方差和信噪比(matlab prepared by the gray image denoising, a total of three methods, and finally to calculate the filtered mean square error and signal to noise ratio)

TP1_loi_de_bernouli avec matlab

kmean clustering algorithm. this code will take the training data set (with out class lebel) as input and return the no of optimum centre used in rbfn by using eucleadian distance.

利用Matlab编程计算最短路径及中位点选址(Calculated using Matlab programming shortest path and site location)

利用Matlab 画出透镜位相因子的分布（未进行近似展开前和近似后的）图形(Matlab to plot the distribution of the lens phase factor (approximate expansion and approximate) graphics)

说明：  注水算法是根据某种准则，并根据信道状况对发送功率进行自适应分配，通常是信道状况好的时刻，多分配功率，信道差的时候，少分配功率，从而最大化传输速率。实现功率的“注水”分配，发送端必须知道CSI。(Water injection algorithm is to allocate transmission power adaptively according to certain criteria and channel conditions. Usually, when the channel is in good condition, more power is allocated, and when the channel is poor, less power is allocated, so as to maximize the transmission rate. To realize the "water injection" distribution of power, the sender must know CSI.)

采用reed-muller码降低ofdm的par方法(used reed-cup code to reduce the par method ofdm)

对微波基础理论的Matlab仿真。对于微波初学者有借鉴作用。(based on microwave theory of Matlab. Microwave for a beginner lessons.)