sudu

谐波分析简要过程 主要对常见的谐波定义，分析过程，处理的手段，仿真结果等作一个简要的概述(harmonic analysis process a simle but important applied in every engineeering aera especially in electical engeneering department if it has some error in the document please excuse cause of time and limited brain)

图像的otsu分界算法的实现，不是调用函数的，是底层实现(otsu partition)

说明：  matlab 机器人避障仿真 同时定位与地图创建程序(the robot slam simulation)

有限元算法求解铁木辛柯梁梁静力问题实例。一个简单的一维梁模型，用FEM算法求解，用于学习有限元编程。(Timoshenko beam in bending)

说明：  自己编的 利用隐式马尔科夫过程进行目标状态估计(Using implicit markov process to estimate target state )

本程序实现了中继协作时候对中继选择时候根据信噪比对中继的排序选择工作(implemente the relay system s order of the relay)

MATLAB中时延差分方程的解法代码及规则和例程(Solutions of delay difference equations in the MATLAB code and rules and routine)

DTW算法的程序，申请两个n*m的矩阵D、d,分别为累积距离和帧匹配距离。这里n和m为测试模版与参考模版的帧数。然后通过一个循环计算两个模版的帧匹配距离d。接下来进行动态规划，为每个格点 （i，j）都计算其三个可能的前续格点的累积距离D1，D2，D3。考虑到边界问题，有些前续格点可能不存在，因此加入一些判断条件最后利用最小值函数min()，找到三个前续格点的累积 距离作为累积距离，与当前帧的匹配距离d（i，j）相加，作为当前格点的累积距离。该计算过程一直达到格点（n，m），并将D（n，m）输出，作为模版匹配的结果。(DTW algorithm procedures, apply two n* m matrix D, d, respectively, accumulated distance and frame matching distance. Where n and m is a reference test pattern and the template frames. Then through a loop to calculate two frames template matching distance d. Next, dynamic programming, for each grid point (i, j) are calculated from the cumulative D1 before the renewal of its three possible lattice point, D2, D3. Taking into account the boundary problem, some former continued grid point may not exist, so add some conditions to determine the final use of the minimum function min (), found three former continued accumulation of grid points cumulative distance as the distance from the current frame to match the d (i, j) added, and a current cumulative distance grid. This calculation has reached the grid (n, m), and D (n, m) output, as a result of template matching.)

说明：  从理论上介绍了MUSIC算法原理、分析了阵列相位误差对MUSIC算法性能的影响(The principle of music algorithm is introduced in theory, and the effect of array phase error on the performance of music algorithm is analyzed)

matlab m文件 输入光谱信号就能求求光谱的半高全宽！！！(Seeking spectrum FWHM)