nrlfppg

说明：  利用matlab环境设计了DEA方法中CCR模型和CCGSS模型的计算程序(Environmental design using matlab CCR DEA model and the method of calculation procedure CCGSS model)

连杆，主要是四杆机构的仿真，界面设计，以及返回函数的编写，和文本框的设置(Kinetic analysis and dynamic simulation of the planar rod robot in the MATLAB Simulink-based)

Bit plane slicing using MATLAB

turbo编码和三种解码方法的matlab程序(turbo code and decode)

说明：  电缆阻抗求取程序，高频电缆串联阻抗，根据高频中压电缆模型建立，(Cable impedance calculation program)

用matlab进行发送天线为2根，接收天线为1根的mimo信道空时分组码的性能仿真。(Using matlab to send antenna 2 and receiving antennas to one of mimo space-time block codes channel performance simulation.)

一种基于压缩感知的正弦信号重构算法，已经经过仿真验证(A sinusoidal signal reconstruction algorithm based on compressed sensing has been verified through simulation)

this is a matlab code with a gui that designs a shaft depending on the type of material needed the loads acting on it and the factor of safety

FDTD程序关于一维时域有限差分法（分层介质，反射，透过系数-FFT）(1-D FDTD code with simple radiation boundary conditions)

Dijkstra最短路算法 flod算法：求任意两点之间的最短路.可以把矩阵直接带进去求解。(Dijkstra shortest path algorithm flod algorithm: seeking the shortest path between any two points. Can be brought directly into the matrix to solve.)