mc_cdma

用于空域特征检测的几个代码，很实用,而且结果也很好哦！希望大家来共同进步(several codes for detecting of spatial characteristics)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

There are 3 models of Buck converter closed loops with PWM done in simulink and they work properly

adaboost工具箱,可以运行，初学者过来看看。(adaboost toolbox, you can run, beginners come to see.)

matlab插值方法，二次差值，分块插值等(matlab interpolation method, the second difference, block interpolation)

说明：  Gauss elimination method to solve system of equations

关于典型雷达信号的侦察分析和雷达干扰建模与仿真，为雷达系统仿真提供了重要的模块。 (For typical radar signal reconnaissance and radar interference analysis modeling and simulation for radar systems provide an important module emulation.)

自适应均衡器设计，采用分数间隔、判决反馈结构，MMSE算法。(Adapt a FSE+DFE combination for square M-QAM over T/2-spaced microwave channels with AWGN initialized by Unbiased MMSE-FSE receiver )

连续信号（可以自定义的函数）的FFT效果图，初学者学习的例程，不错(Continuous signal (can custom functions) of the FFT renderings, for beginners to learn the routine, good)

Softdec including the function poly2trellis(Viterbi Algorithm in soft decision)