登录
首页 » matlab » LP02

LP02

于 2013-09-24 发布 文件大小:1KB
0 241
下载积分: 1 下载次数: 8

代码说明:

  利用模式理论,对给定几何尺寸以及折射率分布的光纤进行模式求解与绘图,该程序给出LP02模的求解与绘图。(the LP02 mode of the fiber)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • qam-re-tr
    QAM Matlab程序,误码率的坐标,星座图等在图中已经显示出来(QAM Matlab procedure, the coordinates of BER, constellation diagram, etc. At chart has been displayed)
    2009-03-15 12:40:31下载
    积分:1
  • matrixsimulink
    simulink file for matrix converter
    2010-12-28 14:27:39下载
    积分:1
  • optimization-toolbox
    matlab 最优化工具箱,解决非线性多目标问题的首选(matlab optimization-toolbox)
    2012-01-12 11:51:41下载
    积分:1
  • StdCellPlacementTool
    StandardCell Placement Tool Using Graph Theory
    2014-02-20 22:29:09下载
    积分:1
  • 11
    说明:   该电路由一片四双向模拟开关集成电路CD4066为核心构成。每个电路内部有四个独立的能控制数字或模拟信号传送的开关。当水箱无水时,由于180K电阻的作用,使四个开关的控制端为低电平,开关断开,LED 不发光。随着水位的增加, 由于水的导电特性,使得IC的13脚为高电平,S1接通,LED1点亮。当水位逐渐增加时,LED依次发光指示水位。水满时, LED4发光, 显示水满。同时T1导通, B发出报警声,提示水已满。不需要报警声时,断开开关K即可。 (The circuit consists of a four-way analog switch integrated circuit CD4066 core composition. Within each circuit to control four separate digital or analog signal transmission in the switch. When the tank water, the role of the 180K resistor, so that the four low-side switch control, switch off, LED does not light. As the water level increases, the electrical properties of water, making the IC' s 13 feet high, S1 connected to, LED1 lights up. When the water level gradually increased, LED turn light level indication. Is full of water, LED4 LED display full of water. At the same time conducting T1, B alarm will sound, indicating that the water is full. Do not need to sound the alarm when the disconnect switch K can be.)
    2011-03-11 11:41:51下载
    积分:1
  • Npso-programing-and-article
    小生境粒子群算法编程,及20篇相关论文,全都是关于小生境粒子群的研究与应用(Niche Particle swarm algorithm programming, and 20 article about NPSO s research and application)
    2020-11-21 09:49:35下载
    积分:1
  • cyclo-converter
    Psim cycloconverter simulation
    2015-02-17 18:20:20下载
    积分:1
  • errorcate
    这是一个计算误码率的文档,里面包含源码及说明,很容易理解(This is a documentation error rate calculation, which contains the source code and instructions, it is easy to understand)
    2011-04-25 17:07:41下载
    积分:1
  • Audio-denoising-deepa
    1. Extract files and run Audio_denoise_main.m file folder... 2. Click on Load & play Audio file and Original sound.wav file 3. Then using slider AWGN (White gauusion noise)...it is vary 1 to 10 set it to 10.. 4. now click on Add Noise and play... 5. u can save noisy signal by save noisy signal tab... 6. now wavelet... 7. thresholding.. 8. now click on Denoise and play....wait for some time...this will take 25 sec time 9. now save that denoised signal...and record all output parameters... 10. now click on clear all and exit
    2015-04-18 14:39:47下载
    积分:1
  • Kmenas_sonar
    说明:  使用matlab工具对sonar数据集进行kmeans分类(Kmeans classification of sonar data set with MATLAB)
    2020-12-20 13:09:10下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载