-
tichuxinghaobaoluo
信号包络,提出信号包络,便于观察信号波动过程,非常有用(Signal envelope, put forward the signal envelope, easy to observe the process of signal fluctuations, very useful)
- 2014-02-25 09:46:33下载
- 积分:1
-
Chapter-4
图书电扫阵列-matlab建模与仿真,第四章编码(codes of book chapter4)
- 2015-06-13 15:37:44下载
- 积分:1
-
LDP
This code calculated the LDP histogram and is based on B Zhang, Y Gao, S Zhao & J Liu, "Local Derivative Pattern Versus Local Binary Pattern: Face Recognition With High-Order Local Pattern Descriptor," Image Processing, IEEE Transactions on, vol.19, no.2, pp.533,544, Feb. 2010
- 2014-06-27 13:07:51下载
- 积分:1
-
SKYhook_suspension
悬架系统的天棚阻尼控制策略,有效减低系统的动载荷,加速度(Ceiling suspension system damping control strategy to effectively reduce the system dynamic loads, accelerations)
- 2020-11-24 19:39:32下载
- 积分:1
-
codes
the attached file contains six MATLAB codes
- 2014-09-01 02:31:52下载
- 积分:1
-
04470072
This paper presents a topology design scheme (HeteTopo) for QoS-based heterogeneity ssues in overlay multicast. The scheme aims at constructing a topology tree with differentiated QoS support for heterogeneous multicast service while optimizing the related tree cost metrics
- 2013-02-19 15:35:45下载
- 积分:1
-
The-method-of-least-squares
利用最小二乘法的原理高精度估计正弦波信号的幅值,频率和初相(The principle of using the least squares method estimated sine wave signal amplitude, frequency and initial phase of high-precision)
- 2013-03-16 19:04:44下载
- 积分:1
-
pulseDsP
这是脉象信号的处理数据,可以得出最佳取脉压力,是很好的处理程序(This is the pulse signal processing data, we can draw the best to take the pulse pressure is a good handler)
- 2013-12-19 21:20:27下载
- 积分:1
-
Converting--Measurenments
一个很完美的解决数据关联问题中坐标转换的文章(A perfect solution data associated coordinate transformation article)
- 2012-11-01 16:29:15下载
- 积分:1
-
Direct_sequence_spread_spectrum
Assume that a direct sequence spread spectrum system uses the Barker code of length 7 (N=7) as its spreading sequence.
a. Randomly generate 8 symbols (d0~d7) from the set {+1,-1}.
b. If each chip of the Barker code is denoted as cj, j=0~6, spread each symbol di by the Barker code. (Please refer to p. 17 of the slides.) Use “stem” to plot the signals before
spreading and after spreading
- 2010-08-11 04:53:11下载
- 积分:1