Tut4_-_IIR

matlab实验课件。详细介绍了matlab最基本的操作和功能，是两学期的内容。适合自学。(Matlab experiment courseware. Introduces in detail the matlab the basic operation and function, the contents of two semesters. Suitable for self-study.)

MATLAB程序设计之无约束最优化算法.MATLAB programming algorithm for unconstrained optimization.(MATLAB program designed for unconstrained optimization. MATLAB programming algorithm for unconstrained optimization.)

fbb sensor qsk based

the above codes are very useful for image segmentation,edge detection

hello world example by using windows dialogs.

说明：  任务：设计一个4×2.5Gbit/s 长距离光纤传输系统，并利用OptiSystem 仿真验证。 要求： 1．采用波分复用技术，波长设置以100GHz 为间隔，频率分别为193.1THz、193.2THz、193.3THz、193.4THz，每个波长传输速率为2.5Gbit/s（NRZ），传输距离为300km。采用常规光纤，光纤损耗系数为0.25dB/km。 2．单通道光发送机最大输出功率为0dBm，光接收机的接收光功率不低于－26dBm，过载点为－10dBm。 3．可以采用EDFA 作为线路放大器，其中EDFA 的输入功率限制在－18～2dBm，最大输出功率20dBm，增益范围为13～25dB，噪声指数4.0dB。(Task: Design a 4 x 2.5 Gbit/s long-distance optical fiber transmission system, and use OptiSystem simulation to verify. Requirement: 1. Using wavelength division multiplexing technology, the wavelength is set at 100GHz intervals, with frequencies of 193.1 THz, 193.2 THz, 193.3 THz and 193.4 THz, respectively. The transmission rate of each wavelength is 2.5 Gbit/s (NRZ), and the transmission distance is 300 km. The loss coefficient of conventional optical fibers is 0.25dB/km. 2. The maximum output power of a single-channel optical transmitter is 0 dBm, and the receiving power of an optical receiver is not less than -26 dBm, and the overload point is -10 dBm. 3. EDFA can be used as line amplifier, where the input power of EDFA is limited to - 18-2dBm, the maximum output power is 20dBm, the gain range is 13-25dB, and the noise index is 4.0dB.)

copon DOA simulation with matlab

这是一本有关MATLAB 的参考书，适合于使用MATLAB 或正在打算使用MATLAB 的读者(This is one of the MATLAB reference for the use of MATLAB or MATLAB is intended to use the reader)

UKF 环形倒立摆仿真。包括能是控制部分。硕士毕业设计原文件。(The UKF ring inverted pendulum simulation.)

demodulator for 8-psk modulation