登录
首页 » matlab » MatlabMoments

MatlabMoments

于 2013-09-22 发布 文件大小:21KB
0 253
下载积分: 1 下载次数: 12

代码说明:

  seismic moment calculation

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • shuxue
    层次分析法求权重权向量等很多东西09年b提(very good)
    2010-08-24 12:53:58下载
    积分:1
  • Burg
    说明:  用MATLAB编的 谱估计里的伯格算法 效果很好(Made use of MATLAB in the Burg spectral estimation algorithm works well)
    2008-09-03 20:56:09下载
    积分:1
  • power_switching_power_supply
    Synchronous Buck Converter: This switched power supply converts a 30V DC supply into a regulated 15V DC supply. The model can be used to both size the inductance L and smoothing capacitor C, as well as to design the feedback controller. By selecting between continuous, discrete and fixed-point controllers, the impact of discretization and using limited numerical precision can be explored
    2014-10-27 17:35:38下载
    积分:1
  • EQ_Calculation
    说明:  简单的eq算法,供参考学习使用,文件为zip打包,代码较为通用可以复用(equalizer compute learn more about)
    2020-06-06 10:28:24下载
    积分:1
  • OFDM_AWGN
    说明:  OFDM在AWGN信道下的仿真,用MATLAB实现,一共有6个程序。(OFDM AWGN under the simulation, using MATLAB, a total of six procedures.)
    2006-04-12 21:01:50下载
    积分:1
  • 18
    说明:  Three phase high frequency isolated DC-DC converter (published in ELSEVIER)is simulated under symmetrical open loop control. It provides Low voltage conversion ratio, isolation, good regulation with fast dynamic response
    2014-10-03 18:29:15下载
    积分:1
  • wfPNN
    说明:  PNN的程序,经过验证的,很好使,希望对大家有所帮助!(PNN procedure, proven, well so, we want to help! )
    2011-04-13 22:16:30下载
    积分:1
  • three_dim_plot
    The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
    2013-07-23 17:56:06下载
    积分:1
  • 1-(1)
    在matlab或者PSCAD中对桥差不平衡电流进行仿真计算,得到仿真结果与常规计算结果一致,此方法修改简单快捷。(In matlab or PSCAD to bridge the difference between the current imbalance in the simulation calculation, the simulation results are consistent with conventional calculations, this method is simple and quick modification.)
    2015-05-22 09:57:17下载
    积分:1
  • emwork3_1_1
    地面上方单导线传输线的单位长度电容的矩量法求解(Ground above the single-wire transmission line capacitance per unit length of the moment method)
    2010-06-01 12:20:54下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载