shearing

说明：  能够更好的熟悉matlab开发环境，里面还配带了许多的实用程序(Better matlab familiar development environment, which is also equipped with a number of utility)

实现了对10个数字音的识别程序通过虚拟阵元进行DOA估计，BP神经网络用于函数拟合与模式识别。( Realization of 10 digital audio recognition program Conducted through virtual array DOA estimation, BP neural network function fitting and pattern recognition.)

Neighborhood rough set based heterogeneous feature subset selection

在matlab中做的高频地波雷达海面回波谱的数值模拟(HF ground wave radar sea return to the numerical simulation of Pope)

Simulink 高手教材，让你简单的掌握这些内容！

利用MATLAB编程实现遗传算法，并结合一维多峰值函数对算法性能进行了测试，在MATLAB环境中采用遗传算法有效地解决了求解函数的优化问题，仿真结果验证了该算法的有效性，图像直观，性能优越，为遗传算法的实际应用开辟了新的途径和渠道。(Genetic algorithms using MATLAB programming, combined with a function Victoria Peak performance of the algorithm was tested in the MATLAB environment using genetic algorithms to effectively solve the problem of solving function optimization, simulation results verify the effectiveness of the algorithm, the image visually superior performance, the practical application of genetic algorithms has opened up new avenues and channels.)

基于LDPC码的信道编码与物理层网络编码联合设计方案(Based on the physical layer channel coding and network coding jointly designed LDPC codes)

在过阻尼情况下，典型二阶系统有两个相异的实数极点，其阶跃响应实际上是两个一阶系统响应的叠加。（ωn＝5），不断增大ζ值，观察每个ζ值下两个实数极点间的距离；同时绘出两个实数极点分别对应的一阶系统响应和二阶系统的响应，观察它们间的关系(In the overdamped case, the typical second-order system has two distinct real poles, and its step response is actually the superposition of the two first-order system response. (Wn = 5), increasing zeta values​ ​ , observing the distance between the two real poles each zeta value draw two real poles, respectively, corresponding to a first-order system response and the response of the second-order system, observe them relationship)

利用相关分析法辨识系统的脉冲响应并比较离散、递推、矩阵三种算法结果，包括M序列的生成(Impulse Response Identification system using correlation analysis and comparison of discrete, recursion, matrix three algorithms results, including the M sequence generation)

说明：  详细介绍了单级倒立摆模型的建立，稳定控制和起摆控制的仿真及实时控制的实现，二级摆和三级摆的控制(Details of the single-stage model of inverted pendulum, stability control and swing control of the simulation and realization of real-time control, secondary and tertiary pendulum swing)