sqq

IPHLPAPI.dll win7 连网无法启动matlab(IPHLPAPI.dll win7 networking can not start matlab)

利用高斯核自行完成高斯平滑。 1.gkernel.m: 创建高斯核。 2.getnorm.m: 将高斯核归一化以求得该核的图像 3.convo.m：不用自带函数求卷积 4.conducting.m: 举例执行程序(1.gkernel.m: Buidling Gaussian kernels. 2.getnorm.m: Normalizing Gaussian kernel in order to display the kernel. 3.convo.m: calculating the convolution. 4.conducting.m: conducting the program with some examples.)

说明：  用MATLAB实现的计算器程序 calculator.fig calculator.m(calculator.fig calculator.m)

一本指导IT技术人员走向金融IT路线的书籍，关于职业生涯规划(a book to guild ITers pave their ways to finantial-IT careers.)

Learning to Program with MATLAB_ Building GUI Tools - Craig S. Lent

GMSK通信建模与仿真，simulink源文件，东华大学研究生通信建模与仿真课程设计代码(Modeling and simulation of GMSK communication simulink source file, donghua university graduate course design of the modeling and simulation of communication code)

用MATLAB编写的EMD（经验模态分解）例程。实现了Hilbert黄变换、经验模态分解等理论算法，里面包含具体应用。(It is EMD sample codes. The Hilbert-Huang transform is coded by Matlab. And the EMD samples are included.)

说明：  本文正是在研究WIMAX/802.16e协议和FMIPv6协议的基础之 上，提出了基于FMIPv6的WIMAX网络快速切换机制，该方案采用跨 层切换的思想，MAC层联合网络层同时进行切换，在链路尚未断开 之前即完成新转交地址(NCOA)获取等功能，从而加快了切换进程， 减小了切换时延和切换时的丢包率。在提出本切换机制的基础上，本 文在NSZ仿真平台上对所提出的切换方案做了系统性的性能仿真，通 过仿真结果验证了方案的可行性和优越性。 ( In this paper, IEEE802.16e standard is described at first. Then an introduction for the basic knowledge and research in MIPv6 and FMIPv6 protocol is given. A fast handover scheme of WiMAX network which based on FMIPv6 protocol is suggested, which implements the fast handover at IP layer associating with MAC layer at the same time. scheme minimizes handover latency by predicting and preparing This the impending handover in advance. Finally, simulation are carried out to evaluate the performance of this fast handover scheme. The result of the simulation shows that the fast handover scheme has good performance. )

Matlab官方文档：matlab图形界面编程(Matlab official documents : Matlab GUI Programming)

characterdatainsertdatabeginning extends D O M Test Case for Andriod.