deorientation

G729 Annex A MATLAB CODE

简单的BPSK误码率仿真曲线，用MATLAB软件，画图很精美(Simple BPSK BER simulation curves, using MATLAB software, drawing a very fine)

Question 1.2 Sullivan

在Matlab下用Simulink进行通信仿真，模拟线性调制，扰码与解扰，低通信号的抽样定理设计 (In Matlab using Simulink for communication simulation, simulation of linear modulation, scrambling and descrambling, low-signal design of the sampling theorem)

Research paper on Power Line interference noise removal techniques from ECG signal. It is a technical paper that reviewed on different methods used.

simulation bad three level

最小均方误差等算法的MSE的计算,随机调制信号下的模拟ppm，连续相位调制信号(CPM)产生。( Minimum mean square error MSE calculation algorithm, Random ppm modulated analog signal under Continuous phase modulation signal (CPM) to produce.)

说明：  在单径瑞利信道中，请设计一种时分的导引辅助的信道估计方法，用Simulink进行仿真，测量BPSK的误码率性能，画出比特信噪比与误码率的关系曲线( in a single path Rayleigh channel, please design a secondary peak guide channel estimation method, the Simulink simulation, BPSK BER performance measurement, signal to noise ratio and bit error rate to draw the relationship between curve)

MATLAB 软件是当今控制系统的设计与仿真中重要的工具软件。该软件仿真方便， 结果直观、准确。本文以单相桥式全波可控整流电路及三相桥式全波可控整流电路为例，叙 述了利用 MATLAB/SIMULINK对整流电路进行建模仿真的方法，并给出了仿真结果波形。 通过对仿真结果分析就可以将系统结构进行改进或将有关参数进行修改使系统达到要求的 结果和性能，这样就可以极大地加快系统的分析或设计过程。 (MATLAB software is the current control system design and simulation of the important tools. The software simulation convenience, the results of direct and accurate. In this paper, single-phase full wave controlled rectifier bridge and three-phase full wave controlled rectifier bridge, for example, describes the use of MATLAB/SIMULINK model of the rectifier circuit simulation method, and gives the simulation results waveform. Through the simulation results of the system structure can improve or modify the relevant parameters of the system to achieve the required results and performance, so that you can greatly speed up the system analysis or design process.)

MATLAB信号系统教程含源码测试通过 复制代码到.m文件即可 (MATLAB Signal System tutorials with source code to the test by copying. M files can)