RCS_xx

本书在对信号处理的理论知识作系统概况和总结的基础上,介绍了如何使用matlab的信号处理工具箱(MATLAB6.x Signal Processing)

It is a C code , also can be used in Matlab. It will help you in detection of people going through a infra red image.

This is a matlab software package for butterworth band pass filter design. you could change the high pass and low pass frequency to design the betterworth filter.

一种新的信号分解方法，极值点对称模态分解。能处理非平稳非线性信号。(A new method of signal decomposition, extreme value point symmetry mode decomposition. Can deal with non-stationary nonlinear signal.)

在1x1的单位矩形中随机部署传感器节点，而且假设每个节点的通信半径一样，要求利用蒙特卡洛算法进行1000次试验分别模拟出连通率随节点数增加以及通信半径增加的变化趋势。(Random units deployed in 1x1 rectangular sensor nodes, and assumed that the communication radius of each node, requires the use of Monte Carlo algorithm to simulate the 1000 trials were increased with the number of nodes increased connectivity and communication radius increasing trends.)

vc与matlab联调，由matlab编写m文件，生成com组件，然后vc调用com组件，完成vc与matlab的接口(FBI vc with matlab, matlab prepared from m file to generate a com component, com component then vc call to complete the vc interface with matlab)

可以直接计算信号的四阶累计量，挺不错的小程序，注意信号必须是非高斯信号哟。(Signals can be directly calculated fourth-order cumulant, very good small procedures, the attention signal must be a non-Gaussian signal yo.)

该文件是关于图像处理的ppt文件，不需要任何语言基础，适合所有的编程爱好者。(ppt file about image processing.useful for programmer regard of programing language)

Matlab环境下基频提取的代码，比较准确(Code to extract pitch in Matlab，which is comparatively correct)

模拟退火算法，五个城市的TSP问题，有数据，和运行结果