matrianswer

模拟陀螺运动程序,本程序是用MATLAB编写的,希望对大家有帮助.(gyro movement simulation procedures, the procedures are prepared by using MATLAB, and I hope to be helpful.)

将多项式转化为向量，很方便你的使用啊学习matlab的童鞋们不用担心了(Into the polynomial vector, it is easy to use you ah)

Patterns of Enterprise application architecture

MATALAB课件和数学建摸的基本实验，对初学者很有帮助。(MATALAB courseware and mathematical modeling of basic experiments, very helpful for beginners.)

本文档是MATLAB详细的教程课件，对MATLAB初学者来说是很好的一部教材。对大家肯定会有很大的帮助的。(This document is a detailed tutorial MATLAB software for beginners MATLAB is a very good teaching. I am sure you will be on a lot of help.)

目录结构 ├─WuYuFei ├─WuYufei_matlab ├─cap_turbo ├─mother └─paper constituent_decoder_SemiTh.m constituent_decoder_logmap.m constituent_decoder_max.m constituent_decoder_Th.m 这四个文件是子译码器 interleaver_3GPP.m 3GPP标准的交织器。Turbo.m中可以选择是用伪随机交织还是3GPP标准交织 decoder_all_algorithm.m 译码器，其中包含了3种译码算法 test_OverLoad_menu.m 对运算负荷的测试程序 test_algorithm_menu.m 对算法的测试程序 Shannon_Limit.m 香农限 test_uncoded_BPSK.m test_uncoded_BPSK_theory.m 未编码BPSK的性能，一个是理论的，另外一个是测试的。(err)

采用独立PD控制，满足二关节机械手定点控制的要求。(Independent PD control, to meet the requirements of the robot sentinel control.)

A MATLAB M-file which automates this calculation and plots the resulting torque-speed characteristic is shown below. It peIfonns the same steps as part a to detennine the speed for each load current, and then calculates the induced torque at that speed. Note that it reads the magnetization curve from a file called f i g9 _ 9 . ma t. This file and the other magnetization curves in this chapter are available for download from the book s World Wide Web site (see Preface for details).

Matlab仿真DSB-SC信号与双极性不归零码实验报告(Matlab simulation of DSB-SC signal with NRZ bipolar experiment does not report)

fuzzy algorithm for pd robot tracking control