MATLAB-GUI-SHEJI

说明：  MATLAB缺陷检测系统 该课题为基于形态学的缺陷检测，素材采用的是光伏板缺陷。通过灰度，二值化，边缘检测，形态学，开闭运算，去除小面积干扰等方法，判断出缺陷所在，定位，并且框出，且计算出各个块面积。配有一个人机交互界面，把缺陷个数，面积等分别显示到GUI界面上。(Matlab defect detection system This topic is based on the morphological defect detection, the material is photovoltaic board defect. Through gray level, binarization, edge detection, morphology, opening and closing operation, small area interference removal and other methods, the defects are identified, located, framed, and the area of each block is calculated. Equipped with a personal computer interface, the number of defects, area, etc. are displayed on the GUI interface.)

this is a homw work for students to get concept

具有反馈控制的动力消振器的响应分析 利用MATLAB中的simulink对消振器进行仿真(With feedback control of dynamic absorber response analysis using MATLAB simulink in the simulation of the damper)

联合迭代重建技术(SIRT) 实现了SIRT算法解决方程组迭代。(Simultaneous iterative reconstruction technique (SIRT) to achieve the SIRT iterative algorithm to solve the equations.)

Orbit determination and control source Matlab code

说明：  传统的波束形成方法，累加延时求和。代码可运行(The traditional beamforming method uses cumulative delay summation. Code can run)

阵元间隔为半波长的均匀分布16元线阵，预成指向士arcsin（(2i-1)/16）(i=l，2，…，8)的16个均匀加权常规波束,远场有5个互不相关的目标源发射信号，每个源相对于基阵的方位为-40，-42，-5，30和33，且每个信号源到达基阵的信噪比相同，均为5DB，快拍数为1000.(Array element spacing of half wavelength for the uniform distribution of 16 per linear array, pre-point disabilities into arcsin ((2i-1)/16) (i = l, 2, ..., 8) of 16 evenly weighted conventional beam, far-field has 5 unrelated target the source of emission signals, each source array relative to the position for the-40,-42,-5,30 and 33, and each signal source to the array signal to noise ratio the same as Scientology, are 5DB, snapshots for 1000)

Gaussian Distribution.

基于峭度的盲源分离，采用FastICA技术，适合初学者(BSS based on kurtosis by FastICA)

说明：  matlab实现的卫星轨道模拟，利用卫星轨道根数参量，通过求解开普勒方程求解卫星轨道模型(err)