863

说明：  本程序用于“多个火电机组、储能电站在电网调度指令的引导下的出力联合优化”，调度间隔为1min（可修改）。(This program is used for "joint optimization of output of multiple thermal power units and energy storage power stations under the guidance of power grid dispatching instructions". The dispatching interval is 1min (modifiable).)

说明：  这是一个PSCAD4.2.1的火电机组模型，容量是660MW。(This is a PSCAD 4.2.1 thermal power unit model with a capacity of 660MW.)

优秀论文配套源码。分布式电源的接入使得配电系统从放射状无源网络变为分布有中小型电源的有源网络。带来了使单向流动的电流方向具有了不确定性等等问题，使得配电系统的控制和管理变得更加复杂。但同时，分布式电源又具有提高电网可靠性，绿色节能，等等优点，所以为更好的利用分布式电源为人类造福，我们必须对其进行研究与分析。 本文采取通过利用仿真软件Matlab编写计算潮流程序模拟分布式电源接入配电网的模型进行潮流计算的方法对分布式电源的稳态影响进行探索与分析。 选取了34节点的配电网网络模型，通过对单个以及多个分布式电源的接入位置以及容量的不同情况对34节点配电网的网损以及节点电压状况进行了分析。 (The distributed generation access to distribution system makes passive radial distribution network to active medium-sized power distribution network. It brings uncertainty to one-way direction power flow, etc., and it makes the control and management of the distribution system more complicated. Otherwise, it can bring a lot of benefits, such as more reliable, and it is green power. The distributed generation should be better known , so we can benefits more. So the program called Matlab was used to compile a program to solve the power flow problem. By this program, we can text which factor can influence the distributed generation’s access to the distribution system. The IEEE 34 Node model was chosen to be discussed how different factors can influence the power quality. This article analyzes distributed generation’s influence to the distribution system of energy lost and voltage level. )

在分析光伏发电原理与光伏电池数学模型的基础上，对由若干光伏阵列组成的大型光伏电站进行PSCAD仿真建模，并分析其运行特性。采用恒电压跟踪方法并利用不同温度下的测量制表值共同实现大规模光伏阵列的最大功率点跟踪(maximum powerpointtracking，MPPT)，并设计了相应的并网逆变器控制策略。最后，对大型光伏电站在正常运行以及站内外发生三相短路故障的情况进行仿真分析。(On the basis of analyzing the principle of photovoltaic generation and mathematical model of PCcells.)

controller based RPM counter

说明：  反应堆热工水力计算软件，由美国开发，这是第5代(Reactor thermal hydraulic calculation software)

这是一个在pscad中建立的电弧模型，这个模型能够用来研究电弧的电流电压特性(This is an arc model built in PSCAD, which can be used to investigate the current and voltage characteristics of arcs)

频率波数域波动方程正演（单点模拟也可随意给）(Frequency-wavenumber domain wave equation forward (single-point analog also be free to give))

STATCOM编程，MATLAB，可直接用(STATCOM)

单相全桥逆变电路，将直流逆变为交流，很好用的软件，提供给matlab新手使用(Single-phase full-bridge inverter circuit to DC to AC inverter, a very good software, made available to the novice to use matlab)