BESs

C8051F02x的大量源程序示例代码，包括汇编和C的代码()

3D打印TMC5130驱动程序，修正了原版的错程问题(TMC5130 river for 3d printer, debug missing step problem.)

红外报警器的c代码。 基于清翔电子的c51单片机最小开发板开发，代码带有注释。如果不布置外围红外电路，IO口检测到低电平触发蜂鸣器报警。必须有液晶1602才能正常运行程序，不然需要注释掉LCD相关代码。(Infrared alarm c code. Based on Qingxiang electronic C51 microcontroller development board, the code with notes. If the peripheral infrared circuit is not arranged, the low level trigger buzzer alarm is detected at the IO port. There must be liquid crystal 1602 to run the program normally, otherwise you need to annotate the LCD related code.)

说明：  stm32永磁同步电机双闭环无感foc代码(Double closed-loop non inductive FOC code of STM32 permanent magnet synchronous motor)

Test LCD for Preteus program.

点阵LED、数码管、独立LED和无源蜂鸣器的驱动模块(Dot matrix LED, digital control, independence and passive buzzer LED driver module)

正弦信号发生器[2005年电子大赛一等奖].files(sinusoidal signal generator [e-Competition in 2005 won first prize]. Files)

说明：  基于STM32的电子墨水屏驱动程序,C语言。(eink driver for STM32)

说明：  nrf52840驱动编写，芯片驱动，芯片手册 嵌入式单片机硬件编程单片机开发 蓝牙协议栈(nrf52840 driver preparation, chip driver, chip manual Embedded MCU hardware programming MCU development)

在stm32平台上实现读取ADXL345的三轴加速度的数据(On the STM32 platform, read the data of the three axis acceleration of ADXL345)