321

这是一个matlab的源程序，只要打开就知道了，具体我久不说了谢谢大家！(This is a matlab source, as long as the Open will know the specific久不I said thank you!)

MATLAB及在电子信息课程中的应用（代码）(MATLAB and in the course of electronic information in the application (code))

作业A和作业B串行（不采用缓输出技术）的时序图 作业A和作业B并发（采用缓输出技术）情况下的一种时序图(Job A and job B serial (non-use of slow output technology) and timing diagram concurrent operation A and operation B (using slow output technology) in case of a timing diagram)

利用GA來模擬鳥群尋找食物的行為，方法就是找尋距離食物最近的鳥之周圍區域及根據自己本身飛行的經驗判斷食物的所在(The use of GA to simulate the behavior of the flock in search of food, the methodology is to find the nearest bird food from around the region and according to their own experience of flying to judge the location of food)

给出了简单的点到点CDMA系统的物理层和链路层联合仿真的Matlab程序。程序不长，但麻雀虽小，五脏据全。有详细的中文注释，相信一看就懂。(is a simple point-to-point system CDMA physical layer and link layer joint Matlab simulation procedures. Procedures are not long, but Sparrow Although small, but it was full. A detailed notes in Chinese, I believe one can understand it.)

This is a code for comparison of 2-PAM, 4-PAM and 8-PAM. Generates a graph of each of the PAM on same figure, easily comparable. Code of 2,4 and 8-Pam included.

针对MUSIC算法在进行信号波达方向(DOA)估计时谱峰搜索运算量大的问题,提出了一种基于FFT多波束算法与MUSIC算法的联合DOA估计方法。该方法采用FFT多波束算法形成多个波束,近似估计信号DOA,获得对应波束指向,再利用MUSIC算法实现对信号DOA的精确估计。这样就只需在该波束指向对应的空域范围内搜索,减小了DOA估计的运算量。(MUSIC algorithm for performing signal DOA (DOA) estimates peak search operation when big problem, a joint DOA estimation method based on FFT algorithm and multi-beam MUSIC algorithm. The method uses FFT algorithm for multi-beam forming multiple beams, approximate estimate signal DOA, obtain the corresponding beam pointing, reuse MUSIC algorithm for accurate estimation of the signal DOA. This will only search within the beam direction corresponding airspace, reducing the amount of computation DOA estimates.)

B样条的方阵生成图形，利用MATLAB生成B样条的源码(B spline matrix generated graphics, the use of MATLAB source code generated B-spline)

rastaplp m-file calculates RASTA-PLP coefficients, defaults to 1 if 0, just calculate PLP coefficients.

维也纳大学，LTE-A下行链路matlab链路级仿真程序。(University of Vienna, LTE-A downlink link level simulation matlab program.)