IEEE-data

求取两个信号的到褶积，通常在用地震方法找油气中用雷克子波和反射系数求取褶积，本程序只是搭建了一个大致的框架，如果需要的到结果，还需要自行设置信号和一些参数。(Strike to the convolution of two signals, typically using seismic methods used to find oil and gas Ricker strike wave and reflection coefficient convolution, this procedure is to build a general framework, if the desired results, you need to set your own signal and some parameters)

面波处理软件CCSWSWIN和速度分层软件CCSWSMAP(Surface wave processing software CCSWSWIN and speed of layered software CCSWSMAP)

基于PSCAD的潮流计算，采用派等值电路，有一个火电厂、一个水电厂、四个变电站。(PSCAD based power flow calculation, using the equivalent circuit, there is a thermal power plant, a hydropower plant, four substations.)

说明：  Madagascar环境下编写的全波形反演程序(Full-waveform inversion program under Madagascar environment)

关于海洋能源的介绍，里面有来发海洋能源的现状、海洋能源的利弊、海洋能源的应用，里面有波浪能、潮汐能(sea resources with application and classification)

锅炉热平衡计算是指输入锅炉机组的热量和锅炉机组输出热量之间的平衡(Boiler heat balance calculation refers to the input heat boiler unit and boiler unit balance between the heat output)

电网仿真模型，适合智能电网，配电有源系统的研究开发啊(smart grid for active power distribution system for protection and control)

这个例子显示了家庭能源管理系统在电网电力和分布式电源之间切换。(This example shows a home energy management system switching between grid power and distributed power sources.)

说明：  先dq变换然后构建电压外环电流内环的双闭环系统，实现了statcom的前馈解耦控制。可以解决大负载投入的电压降落问题。(First, dq transform is used to construct the double closed-loop system of voltage outer loop and current inner loop, which realizes the feedforward decoupling control of STATCOM. It can solve the voltage drop problem of large load input.)

用matlab建立的用于同步发电机三相短路仿真的程序(the simulation model of synchronous generator for three-phase short circuit)