New-folder-(3)

各种功率谱估计算法!包括AR谱估计,BURG算法,YULE-WALK方程(various power spectrum estimation algorithm! Including AR spectral estimation, BURG algorithm, YULE-WALK equation)

PSK QPSK modulaltions

模糊PID控制器matlab simulink仿真,自适应模糊PID控制的仿真文件和模糊规制编写(Fuzzy PID controller matlab simulink simulation, simulation of adaptive fuzzy PID control and fuzzy regulatory documents prepared)

十字交叉阵的波束形成，crossarray beamform(crossarray beamform)

it use to extract thre feature of ecg signal using pca

基于fdtd算法的一维程序，采用matlab进行编写，简单易懂(Fdtd algorithm based on one-dimensional program, using matlab to prepare, easy to understand)

matlab环境下编写的求解等熵涡问题，属于CFD入门级代码(matlab environment prepared isentropic vortex problem solving, is the entry-level CFD code)

阵列信号处理 频率和角度联合估计 JAFE算法(Array signal processing frequency and angle joint estimation algorithm JAFE)

模拟频分复用系统，仿真了6路公用信道的ssb调制的频分复用系统(Simulation of frequency division multiplexing system, simulation of no.6 public channel of SSB modulation frequency division multiplexing system)

说明：  任务：设计一个4×2.5Gbit/s 长距离光纤传输系统，并利用OptiSystem 仿真验证。 要求： 1．采用波分复用技术，波长设置以100GHz 为间隔，频率分别为193.1THz、193.2THz、193.3THz、193.4THz，每个波长传输速率为2.5Gbit/s（NRZ），传输距离为300km。采用常规光纤，光纤损耗系数为0.25dB/km。 2．单通道光发送机最大输出功率为0dBm，光接收机的接收光功率不低于－26dBm，过载点为－10dBm。 3．可以采用EDFA 作为线路放大器，其中EDFA 的输入功率限制在－18～2dBm，最大输出功率20dBm，增益范围为13～25dB，噪声指数4.0dB。(Task: Design a 4 x 2.5 Gbit/s long-distance optical fiber transmission system, and use OptiSystem simulation to verify. Requirement: 1. Using wavelength division multiplexing technology, the wavelength is set at 100GHz intervals, with frequencies of 193.1 THz, 193.2 THz, 193.3 THz and 193.4 THz, respectively. The transmission rate of each wavelength is 2.5 Gbit/s (NRZ), and the transmission distance is 300 km. The loss coefficient of conventional optical fibers is 0.25dB/km. 2. The maximum output power of a single-channel optical transmitter is 0 dBm, and the receiving power of an optical receiver is not less than -26 dBm, and the overload point is -10 dBm. 3. EDFA can be used as line amplifier, where the input power of EDFA is limited to - 18-2dBm, the maximum output power is 20dBm, the gain range is 13-25dB, and the noise index is 4.0dB.)