inner_inter_demo

中值滤波函数，用matlab遍写的中值滤波函数，可以在程序中改写滤波模板的大小，自己设定。(Median filter function written with matlab times the median filter function can be rewritten in the program the size of the template filter, self-imposed.)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

一个很好的盲源分离matlab程序，采用了FastICA算法，计算速度快，说用方便(Matlab program a good blind source separation using FastICA algorithm, calculation speed, said with convenience)

通过传统互相关的方法来进行声源定位的程序,最后实现延迟差的估计(Estimated by the traditional method of cross-correlation to the sound source localization process, the final realization of the delay difference)

this file content simple example about modulation bit stream.the type of modulation is (FSK,PSK and ask) after modulation data send and received after that show the relationship between signal to noise ratio (snr) and the bit error rate (ber).....

喷泉码lt编码过程及验证程序，希望对大家有用(lt-code)

此程序是对图像进行融合，早matlab环境下进行调试，以便得到人们需要的图像，(This program is the integration of images, early matlab environment for debugging, in order to get people need to image)

正弦波脉宽调制技术（SPWM）相电压波形的产生与实现(Phase voltage waveform of the sinusoidal pulse width modulation (SPWM))

OFDM的性能仿真，多址接入方式，可以运行，已经运行成功(Performance simulation of OFDM, multiple access methods, you can run, has been running successfully)

按照给定指标采用模拟低通滤波器（巴特沃思低通或者切比雪夫低通）去逼近理想模拟低通滤波器 ，然后通过双线性变换法对模拟滤波器进行数字化，得到数字滤波器 。(According to a given target analog low-pass filter (Butterworth or Chebyshev low-pass low-pass) to approximate the ideal analog low-pass filter, then through the bilinear transformation method to digitize the analog filters, digital filters has been .)