TM-28-initial-code-V0.1

三轴加速度传感器ADXL345的驱动程序,基于STM32F4.(Triaxial accelerometer ADXL345 drivers, based STM32F4.)

28335的spwm输出，开环测试，三相spwm信号分别为epwm1~6，频率为20KHz(spwm output 28335, the open-loop test, three-phase spwm signals are epwm1 ~ 6, frequency 20KHz)

实现AVR单片机的矩阵键盘的扫描法的C源代码(AVR MCU matrix keyboard scanning method of C source code)

同步串行数据发送电路SSDT的基本功能是将并行数据转换成串行数据并进行同步发送。系统写入和读出时序完全兼容Intel8086时序。 系统以同步信号开始连续发送四个字节，在发送中出现5个1时插入一个0，在四个数据发送结束而下一次同步没有开始之前，发送7FH，这时中间不需要插入零 (synchronous serial data transmission circuit SSDT the basic function is to convert parallel data into serial and the same this step. System write and read sequential fully compatible Intel8086 timing. Synchronized signal system to start sending four consecutive bytes, in this emerging 5 1:00 insert a 0, at the end of four data sent and the next synchronization not started before, sending seven FH, then the middle is not inserted)

PLL锁相环 输入三相电压电流 输出电角度 DQ轴电压电流(Phase Loop Lock Input: 3_phase voltage¤t output: angle & DQ-axis Voltage&Current)

固体材料超弹性和弹塑性计算程序，包含多种材料模型和损伤判据(Program for implicit small and large strain finite element analysis of hyperelastic and elastoplastic solids.)

基于STM32F103的CAN总线接收程序(CAN bus reception based on STM32)

AVR单片机实现RTL8019AS的UDP通讯，由UIP修改而来。(UDP by MCU(AVR))

温度控制系统.运用ds18b20温度传感器将实时温度送入FPGA中，再将温度显示出来(Temperature control systems. Use ds18b20 temperature sensor into the FPGA in real-time temperature, then the temperature is displayed)

单片机基于C8051实现LED模拟交通灯(Microcontroller based C8051 LED simulated traffic lights)